2
．
AW-HS50 Audio Settings
* In order that the audio superimposed on an SDI input signal is can pass through, the setting change below is required.
①
Hold down OSD ON button – (Fig.5-A) for 2 seconds to open the menu. (Hold it down again for 2 seconds to
close the menu.)
②
Use OSD/TIME dial – (Fig.5-B) to set the settings for individual output signals you want to allow to pass through.
Menu:
［
14
］
SYSTEM Menu – (Figure 6)
＞
［
Set the settings for output signals individually. – (Figure 7)
］
<Note>
・
You cannot fix and continue to output the audio of a specific input. When the video is switched, the audio is
also switched together.
・
Even if an SD signal is input in DbyD or UC mode while AW-HS50’s format setting is 1080/59.94i, 720/59.94p
or 1080/50i, the audio is not allowed to pass through.
(*1) If PGM bus or others are selected for the AUX output signal, only the [On] setting of “4. AUX Anci” is not enough
for the audio to pass through.
When the following buses are selected, please change their settings in addition to “4. AUX Anci [On]”.
・
PGM is selected as a source.
⇒
5
．
PGM Anci
［
On
］
・
PVW is selected as a source.
⇒
6
．
PVW Anci
［
On
］
・
MV is selected as a source.
⇒
7
．
MV Anci
［
PGM or PVW
］
* If a selected source is KEY_OUT or CLN, the audio will not pass through.
* Screen shows default settings
(Figure 5: AW-HS50 Control Panel)
（
A
）
（
B
）
(Figure 6: AW-HS50 Menu Display Screen)
4
．
For allowing the audio of a source selected at AUX buss to pass through:
［
On
］
(*1)
5
．
For allowing the audio of a source selected at PGM buss to pass through:
［
On
］
6
．
For allowing the audio of a source selected at PVW buss to pass through:
［
On
］
7
．
Setting for the output signal for Multi View Display
For allowing the audio of a source selected at PGM bus to pass through:
［
PGM
］
For allowing the audio of a source selected at PVW bus to pass through:
［
PVW
］
(Figure 7)
