★
AW-HE40 camera can superimpose the audio signal from an external microphone onto the video signal and can
output it.
Also, it can superimpose the audio onto SDI output through AW-HS50 switcher.
To allow the audio to pass through, both AW-HE40 camera and AW-HS50 switcher require changing the settings.
1
．
AW-HE40 Audio Settings
(Example 1) Using AW-RP50 Controller
*
Below is the explanation about the audio settings of a camera registered as [CAM1].
①
Press the button 1 at <CAMERA STATUS/SELECTION>. – (Fig.1-A)
②
Hold down CAMERA OSD button – (Fig.1-B) for 2 seconds to open the on-screen menu. (Hold it down again for 2
seconds to close the menu.)
③
Use F1 dial – (Fig.1-C) to set the item “Audio” to [On].
【
Location
】
System
＞
Others
＞
Others 4/4
＞
Audio
⇒
[On] – (Figure 2 of next page) * Default: Off
* When “Audio” is [On], the audio-related setting items are available. Set them according to the installation
environment of your cameras. – (Figure 3 of next page)
(*) The HDMI model requires an SDI converter
in order to connect with AW-HS50.
HDMI Connection (*)
(AW-HE40 Rear Panel)
(AW-HS50)
(AW-HE40)
SDI Connection
SDI Connection
AW-HE40 & AW-HS50 – Audio (Passing Through) Settings
（
A
）
（
B
）
（
C
）
(Figure 1: AW-RP50 Control Panel)
Recorder
(Video & Audio Recording)
Schematic View
Specifications of External Audio Input Connector [AUDIO IN]
- Stereo mini-jack (φ3.5mm)
- Mic input: Input level -60dBV±3dBV
* Supported mic: Stereo mic (plug-in power), Supplied voltage: 2.5V±0.5V
- Line input: Input level -10dBV±3dBV
Microphone
