35
Parts and
their functions
Operating
Instructions
Parts and their functions
Camera unit
<Rear panel>
<Bottom panel>
Mount bracket for installation surface
(supplied accessory)
Mount this bracket onto the installation surface, and then
attach the camera main unit to the bracket.
Drop-prevention wire
This wire is screwed down to the bottom panel of the
camera main unit. Loop the circle part of the wire around
the hook of the mount bracket.
Hole for securing the camera pedestal
This hole is provided in the bottom panel of the camera
pedestal.
Wireless remote control signal light-sensing
area
The light-sensing area is provided in three places, on the
front panel of the camera pedestal and at the top of the
rear panel.
Status display lamp
This lights in the following way depending on the status of
the unit.
Orange:
When the standby status is established
Green:
When the power is on
Red:
When trouble has occurred in the unit
Green and blinks twice:
When a signal matched by the remote control
ID has been received from the wireless remote
control (optional accessory) while the power is
on
Orange and blinks twice:
When a signal which is not matched by the
remote control ID has been received from the
wireless remote control (optional accessory)
while the power is on
Camera head
This rotates in the up and down direction.
Tilt head
This rotates in the right and left direction.
Tally lamp
This comes on or goes off in response to the control from
the controller but only when “On” has been selected as the
tally lamp use setting.
RS-422 connector [RS-422]
This RS-422 connector (RJ45) is connected when
exercising serial control over the unit from an external
device. Use a cable with the following specifications for the
connection to this connector.
The tally lamp can be lit by shorting the TALLY signal
(pin 2) with GND (pin 1).
Do not apply a voltage to the TALLY signal pin.
LAN cable
*
(category 5 or above, straight cable),
max. 1000 meters [3280 ft]
*: Use of an STP (shielded twisted pair) cable is
recommended.
Pin No. Signal name Pin No. Signal name
1
GND
5
TXD+
2
TALLY
6
RXD+
3
RXD–
7
—
4
TXD–
8
—
Summary of Contents for AW-HE120K
Page 51: ...51 Memo...