Panasonic AJD440 - DVCPRO PLAYER, Operating Instructions Manual

Page: 7 / 68

– 7 –
POWER switch
When the ON side is pressed, the power is switched on, and the counter display lights up.
Cassette insertion slot
The M cassette, L cassette and consumer cassette (S cassette) with adaptor are inserted
into this slot.
Consumer cassettes can be played back only.
EJECT button
When this is pressed, the tape is unloaded and several seconds later the cassette is
automatically ejected. When the counter display indicates “CTL”, the display is reset.
EDIT/EDIT REC/REC/REC INH lamps
(AJ-D450 only)
EDIT:
EDIT REC:
REC:
REC INH:
REMOTE lamp
This lights when the REMOTE/LOCAL switch has been set to the REMOTE position.
WIDE lamp
This lights when the unit is in 16:9 wide screen mode.
Consumer cassette insertion display lamp
This lights when a cassette recorded on a consumer DV device has been inserted.
SCH lamp
This lights when the SCH of the external sync signal is within a specific range.
SERVO lamp
This lights when the drum servo and capstan servo have locked.
Channel condition lamps
One of these lamps lights in accordance with the error rate status. (Green
→
blue
→
red)
Green:
Blue:
Red:
Level meters
These indicate the PCM audio signal CH1/CH2.
The audio signal indicates the input signal levels during recording and EE selection, and
the output signal levels during playback.
Cassette insertion display lamp
This lights when a cassette has been inserted into the unit.
Counter display
This displays the TC and CTL count values, on-screen information and other messages.
This lights when the error rates for the video and audio playback signals are both
acceptable.
This lights when the error rate for the video or audio playback signals has
deteriorated.
The playback picture will remain normal even when this lamp lights.
This lights when the video or audio signals are subject to rectification or
interpolation.
q
w
e
r
t
y
u
i
o
!0
!1
!2
!3
This lights when the editing mode is chosen from the 9P remote control.
This lights when editing from the 9P remote control.
Thsi lights during video recording.
This lights when the accidental erasure prevention mode has been set for the
cassette. In this state, neither recording nor editing is possbile.