Panasonic AJ-SD93P/E, Service Manual

Page: 42 / 180

INF-29
D-SUB 25 Pin
ｽﾄﾚｰﾄｹｰﾌﾞﾙ
ｽﾄﾚｰﾄｹｰﾌﾞﾙ ｽﾄﾚｰﾄｹｰﾌﾞﾙ
ｽﾄﾚｰﾄｹｰﾌﾞﾙ
PC
P1 Connector
VFK1590
CPLD Writer
AJ-SD93
P201 Connector
Standard Accessory:
VFK1590P1, VFK1590P2, VFK1590P3,
VFK1590P4, VFK1590P5 (5 kinds)
P401 Connector
P301 Connector
CN401 D-SUB Connector
CN301 D-SUB Connector
CN201 D-SUB Connector
CN1 D-SUB Connector
Note:
Individual connection
cable is available as
spare part.
P501 Connector
12-2-5. PLD Version Upgrade Procedure [SERVO IC]
This Model uses PLD on the SERVO Board. At the time of a version upgrade, use the special tool, connect to PLD
Connector on the SERVO Board, and use the PLD writing software as shown table 12-1A-1.
1. Preparation
ITEM REMARK
CPLD WRITER VFK1590, VFK1590P2 (VFK1590 standard)
D-sub 25pin-25pin Cable Straight (Male - Female), Length : Within 1meter
Version Upgrade
Software
MAX+plus II Software ver9.6 or over ver9.6
Access to
www.altera.com/support/software/download/sof-download_center.html
and
select “ASAP 2” in programming software portion in order to download it.
File NAME
jcf File (Included in “
VSI4319A
” file).
(Copy all files of the
VSI4319A
which is included " *.jct " file to floppy disk)
Personal Computer
WINDOWS 95

or 98

Table 12-2E-1
2. Connection
1. Connect the D-sub Cable between CN201(for ALTERA) connector of the CPLD WRITER (VFK1590) and
Personal Computer (Printer port).
2. Connect the CPLD WRITER Cable (VFK1590P2) between P201(for ALTERA) connector and P250 connector
on the SERVO Bord in the VTR as shown in figure 12-2E-2 and table 12-2E-3.
3. Turn on the VTR and Personal Computer (Windows mode).
Figure 12-2E-2
Connection Between CPLD Writer/PC Connection Between CPLD Writer/SERVO Board IC
Manufacture
Cable Connector Ref. No. Cable Part No. CPLD Ref. No. Connector on
SERVO Board
ALTERA D-SUB 25Pin
Cable (Straight)
CN201 VFK1590P2 P201 P250
Table 12-2E-3
3. Boot up the Ver. up Software and Ver. up Procedure
1. Insert floppy disk (which is included all files of the
VSI4319A
) to floppy drive.
2. Select “start button” on the Windows Screen and then “Program” and then boot up the “MAX+plus
II *** programmer only” so that the following menu appears.