– 20 –
Chapter 2 Description of parts — Shooting and recording/playback functions section
- The subject is a high-contrast scene.
8 <WHITE BAL> switch (pages 54, 55)
Select the method for adjustment of the white balance.
<PRST>:
Set the switch to this position when you have no time or are otherwise unable to adjust the white balance.
f
The factory setting is 3200 K.
f
The color temperature can be changed successively to 3200 K, 5600 K, and the user-specified variable value by setting the main menu
→
[SW
MODE]
→
[W.BAL PRESET], or by pushing the <AUTO W/B BAL> switch towards the <AWB> side, and pushing the <AUTO W/B BAL> switch
towards the <AWB> side again while the color temperature is displayed. The variable value can be set with the jog dial button. (page 55)
<A>/<B>:
Pushing the <AUTO W/B BAL> switch towards the <AWB> side adjusts the white balance automatically and saves the adjusted value to
<A> or <B>.
f
Selecting [Bch] from the main menu
→
[SW MODE]
→
[ATW] allows you to assign auto tracking white balance (ATW) function to <B>. (page 55)
9 Focal plane index < >
Indicate the focal plane of the MOS sensor.
It provides a reference for measuring the accurate focal distance from the subject.
Shooting and recording/playback functions section (recording unit)
HOLD
COUNTER
RESET MONITOR SEL
/REW
STOP
FF/
PLAY/PAUSE
CAM
AUDIO
SETUP
SET
THUMBNAIL
KEY LOCK
TOP
MULTI SEL
EXIT
CANCEL BOTTOM
MENU
SHIFT
HOME
LIGHT
0
-10
-18
-20
-30
dB
TC
NDF SLAVE P -REC
1
2
MEDIA
E
F
BATT
E
F
CH1
CH2
A
2
3
6
14
13
12
23
18
22
21
20
19
15
1
7
8
11
16 17
5
24
10
9
4
Press this button to start recording. Press it again to stop recording.
This button has the same function as the VTR button on the lens side.
2
<SDI OUT/IN (OP)> terminal (page 75)
This is the output terminal for SDI signals.
f
Attaching the HD/SD SDI input board AG-YA600G (optional) allows you to input the SDI signal. (page 209)
3 <MON OUT> terminal (page 75)
This is the output terminal of the video monitor. Video independent from the <SDI OUT/IN (OP)> terminal can be output. Also, you can select the
HD SDI signal, the SD SDI signal that you down-converted, or the VBS signal on the [SET02:MON/HDMI FORMAT] screen of SmartUI. Cross-
conversion and up-conversion are not supported.
Connect the LAN cable.
@
@
NOTE
t
For the cable to be connected to the <LAN> terminal, use the shielded cable.
5 <USB2.0> terminal (sub-host) (pages 179, 180)
Mount the wireless module AJ-WM30 (optional). Or, attach the USB 2.0 extension cable connecting the body and the 4G/LTE USB modem
(optional).
6 <FOCUS ASSIST> button (page 52)
Switch on/off the focus assist function.
7 Busy (active status indication) lamp (page 84)
Indicate the active status of the SD memory card, and is illuminated when the card is active.
