– 248 –
Chapter 9 Maintenance — Warning system
6 Recording error
Status display
Does not display.
Warning lamp
Flashes four times per second during continuous recording.
Tally lamp
Flashes four times per second during continuous recording.
Viewfinder
The [REC WARNING] display and rows beneath display the cause.
f
Displayed only while the error occurs during recording. However, it is retained for at least three seconds.
f
When recording stops due to an error, it is displayed until the P2 card operates.
f
[TEMPORARY PAUSE] may be displayed instead of [REC WARNING]. For details, refer to “Warning information
Alarm
Sounds four times per second during continuous recording.
Warning content
This is a recording or recording circuit setting error.
Recording or playback operation
Recording may be continued or stopped.
Action to take
Start recording again. Or, turn the power off once and then start recording again.
7 Card error
Status display
Does not display.
Warning lamp
If the error occurs during recording, it flashes four times per second for approx. three seconds after recording stops.
It does not flash when it occurs during playback.
Tally lamp
If the error occurs during recording, it flashes four times per second for approx. three seconds after recording stops.
It does not flash when it occurs during playback.
Viewfinder
[CARD ERROR] (slot number) is displayed.
f
When recording stops due to an error, it is displayed until the P2 card operates.
f
Displayed when it occurs during playback. (for at least three seconds)
Alarm
If the error occurs during recording, it sounds four times per second for approx. three seconds after recording stops.
It does not sound when it occurs during playback.
Warning content
A P2 card error occurred during recording or playback.
Recording or playback operation
The current operation will stop. After it stops, the P2 card for which the error occurred is write-protected.
Action to take
Replace the P2 card.
8
Reduced wireless audio reception
Status display
Does not display.
Warning lamp
Flashes four times per second. (When idle or during recording)
Tally lamp
Flashes four times per second during continuous recording.
Viewfinder
The [WIRELESS RF] display illuminates.
Alarm
Sounds four times per second during continuous recording.
Warning content
The error indicates poor wireless audio reception conditions.
Recording or playback operation
The current operation will continue.
Action to take
Check the microphone power supply and the reception status of the receiver.
9 Battery near end
Status display
One battery charge level bar flashes.
Warning lamp
Flashes once per second.
Tally lamp
Flashes once per second.
Viewfinder
The [BATT] lamp flashes once per second if the viewfinder has the [BATT] lamp. ([%] indication flashes if the viewfinder
has [BATT STAT] or [ENDURA STAT].)
Alarm
Sounds four times per second.
Warning content
The battery is about to run out.
Recording or playback operation
The current operation will continue.
Action to take
Change the batteries as needed.
10 P2 card recording near end
Status display
One P2 card remaining capacity bar flashes.
Warning lamp
Flashes once per second during continuous recording.
Tally lamp
Flashes once per second during continuous recording.
Viewfinder
The remaining P2 card capacity indicator flashes.
(If the viewfinder has the [SAVE] lamp, and [P2CARD] is set in the main menu
→
[VF]
→
[VF INDICATOR]
→
[SAVE
LED], the [SAVE] lamp flashes once per second (during recording, while recording pauses and stops)).
Alarm
Sounds once per second during continuous recording.
Warning content
The P2 card memory free space totals 2 minutes or less.
Recording or playback operation
The current operation will continue.
Action to take
Change the P2 card or insert an additional card as needed.
11 Fan stop
Status display
Does not display.
Warning lamp
Flashes four times per second.
Tally lamp
Does not display.
