– 247 –
Chapter 9 Maintenance — Warning system
Warning system
Warnings description list
If an error is detected immediately after the camera turns on or during operation, the <WARNING> lamp, the lamp on the viewfinder screen, and an
alarm indicate the error.
@
@
NOTE
t
The priority order of each item is the warning lamp, tally lamp, and alarms, and if multiple errors occur simultaneously, highest priority one is indicated.
“Reduced wireless audio reception” may not be indicated depending on the setting in the main menu
→
[I/F SETUP]
→
[MIC/AUDIO]
→
[WIRELESS
WARN].
1 System error
Status display
The error code is displayed in the time code display.
Warning lamp
Flashes four times per second.
Tally lamp
Flashes four times per second.
Viewfinder
The [SYSTEM ERROR] display, error codes, and, on the lower line of these, the cause are displayed.
Alarm
Sounds continuously.
Warning content
Standard signal error or communication error.
Recording or playback operation
Stops.
Action to take
Check the factor display “Error code” and consult your dealer.
2
Mismatched format
Status display
The error code [E-31] is displayed in the time code display.
Warning lamp
Flashes four times per second.
Tally lamp
Flashes four times per second.
Viewfinder
[TURN POWER OFF] and [SYSTEM MODE] are displayed.
Alarm
Sounds continuously.
Warning content
An internal mismatch occurs in system mode and a restart is required.
Recording or playback operation
Does not operate.
Action to take
Follow the message to turn the power off once, turn the power on again, and check that there is no error display.
3 Card removal error
Status display
The error code [E-30] is displayed in the time code display.
Warning lamp
Flashes four times per second.
Tally lamp
Flashes four times per second.
Viewfinder
[TURN POWER OFF] and [P2 CARD] are displayed.
Alarm
Sounds continuously.
Warning content
An error occurred in the camera built-in memory because the P2 card being accessed was ejected.
Recording or playback operation
Does not operate.
Action to take
Follow the message to turn the power off once and turn the power on again. Ensure that there is no error in the clips on
the ejected card, and repair the clips as necessary.
4 Battery end (low voltage input)
Status display
Seven battery charge level bars flash.
Warning lamp
Lights.
Tally lamp
Flashes once per second.
Viewfinder
The [BATT] lamp is illuminated if the viewfinder has the [BATT] lamp. [EMP] flashes in the battery charge level display.
([%] flashes for [BATT STAT] and [ENDURA STAT].)
Alarm
Sounds continuously.
Warning content
The battery has run out.
Recording or playback operation
Stops.
Action to take
Change the batteries.
If the external AC adaptor is inserted from the <EXT DC IN> terminal, the warning will be released.
5 P2 card end
Status display
Seven media charge level bars flash.
Warning lamp
It stays illuminated until some operation is performed after recording.
Tally lamp
It continues to flash four times per second until some operation is performed after recording.
Viewfinder
The [END] display flashes in the P2 remaining charge display.
(If the viewfinder has the [SAVE] lamp, and [P2CARD] is set in the main menu
→
[VF]
→
[VF INDICATOR]
→
[SAVE
LED], the [SAVE] lamp flashes four times per second.)
Alarm
It continues to sound until some operation is performed after recording.
Warning content
The P2 card space is used up.
Recording or playback operation
Recording will stop.
Action to take
Delete clips in the recording media or insert a new recording media.
