Panasonic AGM1CSRX16T, Reference Manual

Page: 96 / 108

12.4.3 Specifications of the LAN Port
Item Specifications
Number of ports 2
Communication interface Ethernet 100BASE-TX / 10BASE-T
Baud rate 100 Mbps / 10 Mbps, automatic negotiation
Max. segment length
100m
(Note 1)
Max. distance between nodes
100BASE-TX 2 segments
10BASE-T 5 segments
Communication cable Twisted-pair cable (shielded: STP): Category 5e or higher
Communication protocol TCP/IP UDP
No. of
simultaneous
connections
LAN1 Maximum 16 units (System connection: 1 unit, user connection: 15 units)
LAN2
Max. 32 units, general-purpose: 16 units
A cycle restriction is applied depending on the total number of
connections.
Communication method Full-duplex / half-duplex communication
TCP/IP protocol TCP/IP compliant (IPV4)
Functions
● Modifying or holding the network settings (IP, Subnet, Gateway)
● Possible to set the same or different networks between Ethernet ports.
● Routing between Ethernet ports is not performed.
LED display
LINK
Lit when connection is established with the device on the Ethernet
network.
ACT
Flashes when some communication is performed such as transmitting
commands and responses with the devices with established connections.
(Note 1) The standards cite 100m as the maximum, but noise resistance measures such as attaching a ferrite
core may be necessary in some cases, depending on the usage environment. Also, it is recommended
to position a hub near the control board, and limit the length within 10m.
12.4.4 Specifications of the RTEX Port
Item Specifications
Baud rate 100 Mbps
Physical layer 100BASE-TX full duplex (IEEE 802.3u)
Cable Shielded twisted pair (TIA/EIA-568B CAT5e)
Topology Ring
Insulation method Pulse transformer
Connector 8-pin RJ45
Maximum cable length Between nodes: 100 m, total length: 200 m
Communication cycle 500 µs to 2 ms
Command update period 500 µs to 4 ms
12.4 Communication Specifications
12-14 WUME-GM1H-01