12
≥
The memory capacity indicated on the label of
an SD card is the total of the capacity for
copyright protection and management and the
capacity which can be used on the unit, a
computer etc.
≥
During prolonged use, the unit’s surfaces and
the SD card will heat up slightly. This is normal.
Always set the mode dial to OFF when
inserting or removing an SD card.
While this unit accesses the SD card (while
or
is being displayed/the access
lamp is lit), do not remove the SD card,
operate the mode dial, turn off the power or
shake or impact the unit.
≥
Be sure to insert miniSD Cards in the dedicated
card adaptor before use. Inserting a card in this
unit without the adaptor may damage the unit
or the card.
≥
Do not insert an empty card adaptor in this unit.
Do not leave the adaptor in this unit while
inserting or removing miniSD Cards. This may
cause the unit to malfunction.
≥
When the LCD monitor gets dirty, wipe it with a
dry soft cloth.
≥
In a place with drastic temperature changes,
condensation may form on the LCD monitor.
Wipe it with soft dry cloth.
≥
When the unit has become very cold, for
example due to storage in a cold area, its LCD
monitor will be slightly darker than usual
immediately after the power is turned on. The
normal brightness will be restored when the
unit’s internal temperature rises.
When using an LCD monitor, do not apply
excessive pressure to the hinge connecting the
monitor to the unit, as shown in the illustrations
below.
Doing so may damage these parts.
Wrong
About the SD card
About the miniSD Card
LCD monitor
Extremely high precision technology is
employed to produce the LCD Monitor screen
featuring a total of approximately 251,000
pixels. The result is more than 99.99%
effective pixels with a mere 0.01% of the
pixels inactive or always lit. However, this is
not a malfunction and does not affect the
recorded picture.
Precaution when using an LCD
monitor
Hinge Area
VQT1Q93_ENG_PP.book 12 ページ ２００８年３月６日 木曜日 午後５時４２分
