Panasonic AG-DV2500E, Service Manual

Page: 104 / 306

2-8
1
ı
Cassette housing assembly
2.6 REPLACEMENT OF MAJOR PARTS
! The disassembly procedures shown in oder of disassembly. To remove the part, it is necessary to have completed all the stages
before it.
! Always use a torque driver and the specified securing torque to tighten screws.
!
Position the mechanism to the unloading end (No Cassette) mode before disassembly or assembly unless otherwise specified.
<Disassembly>
1) Turn the cassette housing motor emergency gear
in the direction of the arrow, while pushing the lock
lever in the direction of arrow 2, then move the
cassette holder so that the cassette holder bar
comes in the position shown in the illustration.
2) Remove two screws (S1), slide the cassette hous-
ing toward the front and remove it by releasing the
lock on the Hook function as shown by arrow 3.
<Assembly>
1) Reverse the disassembly procedure.
2) Screws (S1) should be tightened using a securing
torque of 0.2 N/m (2 kgf/cm).
<Disassembly>
Head cleaner assembly:
1) Remove the screw (S2) and remove the head
cleaner assembly.
Drum assembly:
1) Remove the Drum FPC from the DV/CPU circuit
board CN107.
2) Remove the screw (S3) and remove the drum as-
sembly.
<Assembly>
1) Reverse the disassembly procedure.
2) Drum section screws (S3) should be tightened in
order of
1
—
3
and using a securing torque of
0.04 N/m (0.4 kgf/cm).
2
1
Head cleaner assembly/
2
Drum assembly
Fig. 2.6.1
Fig. 2.6.2
Cassette housing assembly Manually perform
the loading operation so that the cassette holder
bar comes on the position of this screw.
(S1)
(S1)
1
2
3
3
Hold this part
when removing
or attaching
the assembly.
Cassette
holder
Cassette
holder bar
Look lever
Hook
Hook
Cassette
Housing
Motor
Emergency
Gear
(S2)
(S3)
(S3)
(S3)
Drum assembly
Head cleaner assembly
2
1
3
No. Item Ref. Illustration Procedure
Note:
Be sure to attach the cassette housing in the
same position as when it was removed.
(OK) (NG)
Hook function of the Cassette hausing.