- 67 -
≥
When recording horizontal images using a tripod, attach the unit on the tripod using [LEVEL
GAUGE], and set [LEVEL GAUGE] to [ON] again.
≥
Register “Flash band compensation” to a USER button. (
≥
Switch to Manual Mode. (
If you set this item to [ON], you can compensate for and reduce flash band, a phenomenon that
creates markedly different levels of luminance between the top and bottom of the image when
recording is performed in an environment where another camera is firing its flash.
≥
FBC appears on the screen.
≥
This function is not available in the following cases:
j
When the frame rate in [REC FORMAT] is 29.97p or 23.98p (
j
When a setting in [SCENE MODE] is enabled (
)
j
When using [DIGITAL ZOOM] (
j
During Super Slow Recording (
≥
The setting will be turned off in the following cases:
j
If you turn the unit off
j
If you press the THUMBNAIL button
j
If you switch to Intelligent Auto Mode
j
When [USB MODE SELECT] is set to [DEVICE] and this unit is connected to a PC. (
)
≥
This function will fix the shutter speed to 1/60. The shutter speed cannot be adjusted.
≥
Register “PRE-REC” to a USER button. (
This allows the recording of an image and audio to start before you press the recording start/stop
button. AVCHD scenes will be recorded from approximately 3 seconds before the operation, while
MOV/MP4 will be recorded from approximately 4 seconds before the operation.
≥
[P-] is displayed on the screen. After you start recording, the display changes to [P-REC].
≥
Aim the unit at the subject beforehand.
≥
There is no beep sound.
≥
This function is not available in the following cases:
j
During Super Slow Recording (
j
During the Interval Recording (
≥
In the following cases, a 3 second image that precedes the recording of an AVCHD scene or a
4 second scene that precedes the recording of an MOV/MP4 scene may not be recorded:
j
When 3 hours has just passed since you set PRE-REC
j
If the length of time from when [PRE-REC] is set to [ON] to when you start recording is too
short
j
If the length of time from when you display the recording screen by turning it off and on or
pressing the THUMBNAIL button to when you start recording is too short since you set PRE-
REC
j
When the card slot selected for motion picture recording is switched automatically because you
started recording with normal settings or when [2 SLOTS FUNC.] is set to [RELAY REC]
(
≥
Images displayed on the thumbnail in Playback Mode will differ from the motion pictures
displayed at the start of playback.
Flash band compensation
PRE-REC
R68S3_PJPB.book 67 ページ 2016年5月18日 水曜日 午後10時32分