12
T
Q
B
J2
152
12
D:\Publishing\Panasonic\SC-UA30\SC-UA30 E TQBJ2152 En.fm
To check the time
Press [SETUP] to select “CLOCK” and then press
[OK].
In standby mode, press [DISPLAY].
Note:
Reset the clock regularly to maintain accuracy.
Sleep timer
The sleep timer switches off the system after the set time.
Press [SLEEP] to select the setting (in minutes).
To cancel, select “OFF”.
To check the remaining time
Press [SLEEP].
Note:
• The remaining time is shown for a few seconds every
minute. “SLEEP 1” is always shown when only 1 minute
remains.
• The sleep timer always comes first. Be sure not to set an
overlap of timers.
Play timer
(Except for Bluetooth
®
, D-IN and AUX source)
You can set the timer to come on at a certain time to wake
you up.
Preparation
Set the clock.
1
Press [SETUP] repeatedly to select “TIMER ADJ”.
2
Press [
R
,
T
] to set the start time and then press
[OK].
3
Do step 2 again to set the end time.
4
Press [
R
,
T
] to select the source you want to play
and then press [OK].
To start the timer
1
Prepare the source you want to listen to (USB or
radio) and set the volume.
2
Press [SETUP] repeatedly to select “TIMER SET”.
3
Press [
R
,
T
] to select “PLAY ON” and then press
[OK].
“
#
” is shown.
To cancel, select “PLAY OFF”.
The system must be switched off for the timer to
operate.
To check the setting
Press [SETUP] repeatedly to select “TIMER ADJ” and
then press [OK].
In standby mode, press [DISPLAY] two times.
Note:
• The timer starts at a low volume and increases gradually to
the preset level.
• The timer comes on at the set time every day if the timer is
on.
• If you switch off the system and then switch on again while a
timer is in operation, the timer will not stop at the end time.
External equipment
Preparation
• Disconnect the AC mains lead.
• Switch off all equipment and read the appropriate
operating instructions.
Note:
• Do not bend cables at sharp angles.
• Components and cables are sold separately.
• Sound distortion can occur when you use an adaptor.
• If you want to connect equipment other than those
described, refer to the audio dealer.
Using the optical input
You can connect a TV, VCR, DVD player etc., and listen to
the audio through this system.
1
Connect the external equipment.
2
Press [SELECT <, >] repeatedly to select “D-IN”.
3
Play the external equipment.
Note:
• This system supports linear PCM signals.
• Multi-channel source will be converged to 2 channels.
• Sampling frequency: 32 kHz, 44.1 kHz, 48 kHz, up to 96 kHz
• The sound is muted if the signal format or frequency is not
supported.
• If there are sounds coming from the TV’s speakers,
decrease the volume of the TV to its minimum.
SLEEP 30
SLEEP 60
SLEEP 90
SLEEP120
OFF
Rear panel
of this unit
Optical digital
audio cable
(not supplied)
TV (not supplied)
SC-UA30 E TQBJ2152 En.fm Page 12 Monday, August 6, 2018 4:53 PM