1
3
4
INSTALL THE LENS RETAINER.
Remove the two front
assembly screws and remove the retainer. Adjust the projector
lens shift to
center the projector lens.
vertically and horizontally
Squeeze the retainer and work it into the projector opening to
nest into the inside rim of the projector housing with
prongs toward
the ceiling
bottom ridge aligned with the projector bottom-
and
front rib
. Tighten the retainer screws just enough to prevent rotation.
INSTALL THE STE LENS.
After removing the rear STE lens
cover, install the STE lens/mount assembly over the retainer
prongs. Insert and tighten the two assembly screws to secure
(
).
do not over tighten
Remove the front protective film.
ADJUSTMENTS
. Tilt the STE lens in its mount to make any
residual image top curvature the same but opposite that at the
bottom. Make final adjustments to projector zoom and vertical
lens shift to produce the best fit of the image to the screen.
Lock the STE lens tilt by tightening the single Phillips tilt lock screw (do
not over tighten). As desired you may want to adjust the panel
alignment in the projector (see Sony instruction manual).
STE-S4 Installation Steps
Assembly
Screws
Tilt Lock
Screw
Bottom Ridge
Prongs to
Ceiling
www.panamorph.com
PREPARE THE PROJECTOR.
Adjust the projector roll, tilt
and/or yaw so the projector test pattern lines are square to the
screen edges. Adjust the zoom and vertical lens shift so the
test pattern is centered and fits the screen height. Now
show a
2.4:1 movie
instead of the test pattern. Set the Sony anamorphic lens
menu setting to
for a 2.25:1 screen or
for a 2.4:1 screen.
1.32x
1.24x
Set the Sony Aspect button on the remote to
.
V-Stretch
5
DECIDE HOW TO WATCH OTHER CONTENT
. Use the Sony
“Aspect” button to select
(anamorphic to 1.24x) to
Squeeze
watch 16:9 content (including menus) in the screen center, or
Normal
to stretch 16:9 content to fill the entire screen width.
On a 2.4:1 screen zoom down the image to avoid cropping the top and
bottom. Use V-Stretch with 1.24x for 2.0:1-2.2:1 content.
