1
3
4
5
INSTALL THE PROPER LENS RETAINER.
Remove the two
front Phillips assembly screws and remove the rear retainer.
Use this retainer for a ceiling-mounted projector. Use the other
retainer provided for a high shelf-mounted projector (see
illustration on reverse). Manually open the projector lens door. The lens
will prevent door closure but this will not harm the projector. Squeeze
the retainer and work it into the projector opening to nest into the inside
rim of the projector housing with
.
prongs toward the ceiling
PREPARE THE PROJECTOR.
Make sure the projector lens is
horizontally centered in its opening (ie little or no horizontal lens
shift). Adjust the projector roll, tilt and/or yaw so the projector
test pattern lines are square to the screen edges and the test
pattern is centered on the screen. Then
show a 2.4:1 movie
. Use the
Epson “Aspect” button on the remote to select “Anamorphic Wide” and
make sure the projector lens is clean and as dust free as possible.
INSTALL THE CDR LENS.
After removing the rear CDR lens
cover, install the CDR lens/mount assembly over the retainer
prongs. The lens may have some rotational play so rotate as
necessary until a stop is felt at which point the lens is vertically
aligned with the projector. Insert and tighten the two assembly screws
to secure (
).
do not over tighten
Remove the front protective film.
ADJUST THE LENS TILT AND PROJECTOR SHIFT.
Adjust
the projector lens zoom to fill the width of the screen with the
2.4:1 movie. Tilt the CDR lens and adjust the projector vertical
lens shift to make sure the beam is getting through the CDR
lens to fill the screen. There is only a slight variation in vertical image
height with this adjustment but experimentation may lead to the best fit
and geometry. Lock the CDR lens tilt by tightening the single Phillips tilt
lock screw (
). As desired you may want to apply
do not over tighten
additional “Point Correction” and/or “Panel Alignment” at this time (see
Epson manual).
DECIDE HOW TO WATCH 16:9 CONTENT
(including menus).
Use the Epson “Aspect” button on the remote to select “Horiz.
Squeeze” to watch 16:9 content in the center of the screen or
select “Auto” to stretch 16:9 content to fill the entire screen.
CDR-E1 Installation Steps
Assembly
Screws
Tilt Lock
Screw
www.panamorph.com