Panametrics Aurora H2O, User Manual

Page: 55 / 170

Chapter 3. Operation and General Programming
8 Aurora H2O User’s Manual
3.3.8 Starting Up
After proper installation, the Aurora H2O Transmitter can be set up to accommodate the user’s requirements.
Typically, the user may need to configure the analog outputs, trim the analog outputs, and program the digital
outputs. Refer to the Menu Map, Figure 49 on page 29, and complete the following steps. Upon startup, the Aurora
H2O proceeds through several displays until a screen similar to the following appears:
After startup, the screen will need to be unlocked. To unlock the screen, select
Cancel , Enter , Cancel
Note:
In most instances; use the Enter key to save an entry and/or move ahead to the
following screen; use the Cancel key to reject an entry and/or return to the previous
screen.
3.4 Setting Up the Display
When the screen is unlocked, touch the Menu key and the Main Menu appears with
several options. To set up the display, select Display... and press Enter . The following
screen appears:
3.4.1Selecting Primary Units
To select units for the primary display, select Primary and press Enter . The following
screen appears:
Use the arrow keys to highlight the desired units and press Enter . The screen returns to
the Display Menu .


