Features
Alarm kit contains an internal horn and LED light, when the
pushbar is depressed, the LED light will blink and horn will siren
to provide a visible/audible means of signaling that the opening
has been violated.
The alarm kit can be armed or disarmed by key.
The horn is rated at 95 decibel.
The key switch uses a standard 1 1/4" cylinder with S keyway.
The unit operates on one standard 9-volt alkaline battery.
Device includes
"EMERGENCY EXIT ONLY. ALARM WILL SOUND"
decal for application on door or pushbar.
Installtion Instruction
1. Assemble the alarm kit with parts shown below :
10212 ZINS-R7028-00
2. Place the 9V Battery onto the panel.
Cam should be in OFF position before battery is installed.
3. Alarm siren time may be adjust to 1,3,5,and infinite minutes.
To adjust the alarm time, See Figure 1.
4. Remove the end cap and bracket.
5. Slide the cover out.
6. Insert alarm kit.
7. Re-install the end cap and bracket.
Operating Instructions
1. Insert the key into the cylinder and turn counterclockwise to arm the
unit.
2. The siren will sound three short beeps indicating the unit is armed.
3. Depress the pushbar, the alarm should sound immediately and
red/green LED light will blink.
4. Turn the key clockwise to disarm.
Note
1. If alarm siren time is set to infinite minutes, alarm will sound until
battery runs out.
2. Siren will beep and red LED will blink at approximately 6 seconds
intervals when battery is low.
ON
＊
Figure 1
Alarm
time
Figure
1 Min. 3 Min. 5 Min. infinite
ON
1 2
1 2
ON
1 2
ON
1 2
ON
Arm/Disarm
Switch
On/off
control cam
Threaded
Fastening ring
Battery
Battery seat
Switch to Alarm
Alarm time
switch
Cylinder
