Palstar COMMANDER HF-2500 EXPORT, Owner'S Manual, Page: 5 / 30

5
UNPACKING
Carefully remove the Commander HF2500/HF-2500 M
AGNUM
Amplifier from its shipping
carton making sure there is no damage evident from shipping. If there is any damage, notify the
delivering shipper immediately, fully describing the damage.
The HV power transformer was shipped separately, as its weight would damage the cabinet
in transit.
Do not destroy the packing material since it may be reusable later, should you require fac-
tory service or need to transport the Amplifier for any other reason.
TRANSFORMER INSTALLATION
Remove the top cover from the amplifier chassis. Install the transformer following the illus-
trated procedure beginning on next page (page 6).
SHIPPING BLOCK
The 3CPX800A7 tubes are shipped installed in the amplifier, held in place by a Styro-
foam block. Remove the block before use.
200/234 VAC Operation
The Commander HF2500/HF-2500 M
AGNUM
come factory wired for 234 VAC operation.
For best operation, you should use a dedicated 234VAC main capable of supplying 20 Amps of
peak AC current.
Commander Amplifiers manufactured for export are wired for 234 VAC or 200 VAC de-
pending on the final destination.