CONTENTS
Preparation before use
Before using the air conditioner, be sure to check and preset the following.
Remote Controller presetting
The remote controller is
NOT
presetting as Cooling Only Air Conditioner or Heat Pump by manufacturer.
Each time after the remote controller replaces batteries or is energised, the arrowhead will flashes on the
Front of "Heat" or "Cool" on LCD of the remote controller.
User can preset the remote controller type depending on the air conditioner type you have purchased as
follows:
Press any button when the arrowhead flashes and pointing to "Heat, then Heat Pump is set
Press any button when the arrowhead flashes and pointing to "Cool", then Cooling Only is set.
If you don't press any button within 10 seconds, the remote controller is preset as Heat Pump automatically.
Note:
if the air conditioner you purchased is a Cooling only one, but you preset the remote controller as Heat Pump,
it doesn't bring any matter. But if the air conditioner you purchased is a Heat Pump one, and you preset the
emote controller as Cooling Only, then you CAN NOT preset the Heating operation with the remote controller.
Auto-restart Presetting:
The appliance is preset as no auto-restart function by manufacture. If Auto-restart function is needed, follow the
step below to activate this function:
1) Make sure the Air-con's power is off:
2) Press down and hold the Emergency button (ON/OFF )on the indoor unit then electrify.
3) Keep pressing the Emergency button for over 10 seconds until three short beeps are heard.
The Auto-restart function is then activated. To cancel the Auto-restart function, repeat above procedure until four
short beeps are heard.
Safety Precautions ....................................................................................................................
Identification of Parts .................................................................................................................
Remote Controller .....................................................................................................................
Operation Instructions ...............................................................................................................
Maintenance ..............................................................................................................................
Protection ..................................................................................................................................
Troubleshooting .........................................................................................................................
Installation Instructions ..............................................................................................................
1
2
4
6
8
9
10
11