Palram Sierra Series, Assembly Instructions Manual

Page: 3 / 27

Step 8: Apply silicone sealants above beam 8185, in order to prevent water from seeping in.
Step 10: Make sure that the angle between the back wall profile and the panel supporting profiles is 90 degrees.
Step 15: Apply silicone sealants on the inner part of 7997, and connect to the profile as depicted in drawing 15a.
Step 15c: Do not tighten screw 8708 yet, in order to allow the final adjustments done in step 16b.
Step 17a+17c: Please adjust the poles (inside out and sideways) by sliding them to their final position prior to
anchoring. Make sure that the poles distance from the Patio cover side edge does not exceed 54 cm/21.3”.
Step 17b: Adjust the gutter head’s angle according to your needs and tighten screws 8708.
Please note: Anchoring this product is essential to its stability and rigidity. It is required to complete this stage
(Step 19) in order for your warranty to be valid.
* Tighten all screws when completing assembly.
EN
Notes During Assembly
Steps
0-54cm
0”-21
¼
”
0-54cm
0”-21
¼
”
5-54cm
2”-21.3”
5-54cm
2”-21.3”
A
B1
B2
13 º
17
º
C
15_05_V1
•
Use a soft platform below the parts to avoid scratches and damages.
•
Product dimensions can be adjusted to your specific needs:
1. The wall-mounting profile (top-back) can be adjusted from 257 to 283 cm (101.2” to 111.4”) above ground. The
adjusting is done when measuring and drilling (Step 5).
Please note the installation recommendations’ height suggested in Diagram A.
It is possible to fix the Patio Cover back wall height at the lowest point of 257 cm/101.2”. This method is optional if the
assembly conditions and exterior walls do not allow to follow the suggested installation as appears in the manual.
Please note that the product appearance may slightly change as a result, however snow load weight does not change.
2. Poles distance from the wall can be adjusted from 160 to 210 cm (63” to 82.7”) as suggested in Diagram B1.
Poles distance from the side edges can be adjusted from 5 to 54 cm (2” to 21.3”) as suggested in Diagram B2.
The adjusting is done after assembly and before anchoring (Step 17) by sliding poles and profile 8189+8190 at the roof
profiles’ channels.
3. Wall mounting and distance from the wall determine the roof angle and the total depth of the product (distance of
gutter from the wall). Higher wall mounting and shorter distance between wall and poles increase the roof angle and
shorten the total depth as suggested in Diagram C.
160-210cm
63” - 82.7”
257-283cm
101.2”-111.4”
Note:
The wall anchoring kit supplied with this product is suitable only for concrete walls.
Other wall types need an accordant wall fixation kit. (Contact your supplier)