Palram Frontier 5000, Assembly Instructions Manual

Page: 2 / 38

Care and Safety advice
Notes (by steps)
step 7
Please follow the instructions as listed in this manual.
Sort the parts and check against the list of contents
For safety purposes we strongly recommend that the product
will be assembled by at least two people.
Some parts have metal edges. Please be careful when handling
components. Always wear gloves, shoes and safety goggles
during assembly.
Do not attempt to assemble the carport in windy or wet
conditions.
Dispose of all plastic bags safely – keep them out of reach of
small children.
Keep children away from the assembly area.
Do not attempt to assemble the carport if you are tired, have
taken drugs, medications or alcohol, or if you are prone to dizzy
spells.
When using a stepladder or power tools, ensure that you are
follow the manufacturer's safety advice.
Do not climb or stand on the roof.
Heavy articles should not be leaned against the poles.
Do not hang or lay on part 216
Please consult your local authorities if any permits are required
to erect carport.
Keep roof and gutters clean of snow, durt & leaves.
Heavy amounts of snow on roof can damage the carport making
it unsafe to stand below or nearby.
This product was designed and produced to be a carport only.
Screw 4000 intended to keep the parts (gable) stable till gutters
will be assembled. If a third person can hold the parts till step 8,
this screw can be assembled with all the others at step 33.
This carport should be assembled on a solid base (such as concrete).
Without solid base, pre-foundation, that will include concrete and
metal, is needed as in option 31 at the end of this manual.
step 34
Cleaning instructions
When your carport needs cleaning, use a mild detergent solution
and rinse with cold clean water.
Do not use acetone, abrasive cleaners, or others special detergents
to clean the panel.
Before stating assembly
This carport must be assembled on a solid base (such as concrete
or asphalt).
Choose your site carefully before beginning assembly. Site surface
(mainly below poles) needs to be level.
During assembly use a soft platform below the parts to avoid
scratches and damages.
If surface is not fully leveled, washer 2026 can be placed undr
part 212 in the lower section.
Some versions of this carport are painted.
If color was scratched during assembly it can be fixed
with the following tints:
Desert Yellow – RAL 1001
White – RAL 9016
Black – RAL 9005
Gray – RAL 7012
2026
2026
206cm / 81”
234.5cm / 92 1 /
4
”
501cm / 197
1/4”
206cm / 81”
338cm / 133
”
300cm / 118
1/4”
192cm
75
1/2”
233cm
91
3/4”
278cm
109
1/2”
IMPORTANT
Please read these instructions
carefully before you start to
assemble this carport.
Please carry out the steps in
the order set out in these
instructions.
Keep these instructions in a
safe place for future reference.