EN
600763B_19.07
IMPORTANT
Please read these instructions carefully before you start to assemble this product .
Please carry out the steps in the order set out in these instructions.
Keep these instructions in a safe place for future reference.
Cautions:
1. Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that
it has been placed or installed in its intended normal operating position and they have been given
supervision or instruction concerning use of the appliance in a safe way and understand the hazards
involved. Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the
appliance or perform user maintenance.
CAUTION -- Some parts of this product can become very hot and cause burns. Particular attention has to
be given where children and vulnerable people are present.
2. The heater must not be located immediately below a socket-outlet.
3. Do not use this heater with a programmer, timer or any other device that switches the heater on
automatically, since a fire risk exists if the heater is covered or positioned incorrectly.
4. Do not use this heater in the immediate surroundings of a bath, a shower or a swimming pool.
5. Do not place the unit close to curtain and/or other flammable objects. Otherwise there will be a
danger of catching fire.
6. Do not cover the unit with anything during operation or a short time after it’s shut down.
7. Do not wrap the power supply cord on the unit.
8. Do not use this unit in place where causticity or volatile air exists, i.e. dust, steam, gas, etc.
9. Do not use this unit as a cloth drier or towel drier.
10. Do not use this unit as a sauna heater.
11. Do not use this unit as a room heater of heat storing.
12. Do not use this unit in place of animal propagating and raising.
13. Do not use this unit in heating system of hot air centre.
14. Do not immerse this unit into water for cleaning.
15. The unit is at high temperature during operation. It keeps hot for a period after shut down.
Potential danger would occur when touching it during this period.
16. The unit must be handled with care, and avoid of vibration or hitting.
17. The unit must be securely grounded during operation.
18. When damaged, the unit must be repaired by professional repairing team.
19. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
20. When assembling, keep clear from any board or flammable material.
21. This appliance is not intended for use by persons (including children) with reduced physical, sensory
or mental capabilities, or lack of experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person responsible for their safety.
22. The unit is for household use only. It’s not allowed to use in building site, greenhouses, barn or stable
where there’s flammable dust.
23. The head of the unit is at high temperature during operation. Unplug the unit and wait till it’s cool
before cleaning.
24. The unit should be plugged in a socket, which is easily visible and reachable.
WARNING:
This heater is not equipped with a device to control the room temperature. Do not use
this heater in small rooms when they are occupied by persons not capable of leaving
the room on their own, unless constant supervision is provided.
Preparation
1. Unpack the carton. Take out the accessories pack from the carton. Make sure the
accessories listed in the above Accessories Check List are included. If anything missing,
ask the retailer immediately to provide it to you.
2. Prepare a cross head screw driver and a spanner suitable for M6 screw nut.
3. Read this instruction manual carefully before installation and use. Keep this instruction
manual in a proper and safe place for future use in case needed.
Installation:
1. The heater must be installed under a ceiling or on a wall at least 1.8 metres above from
the floor. When installing the heater, please keep a distance of at least 20 cm from every
direction. Please keep away from flammable materials.
2. Options1: Wall / Ceiling, drill 2 holes on the ceiling or wall. Insert the 2 expansion bolts
into the holes. Use a spanner to twist the screw nuts on the expansion bolts clockwise
till they are securely located in the holes. Unscrew the screw nuts and put them aside
with washers, spring washers for further use later.
Option 2: Product’s profile, drill 3 holes using drill screws in order to secure the bracket
on to the profile.
3. Put Steel Board onto the ceiling or wall. Let the 4 Expansion Bolts go through the 4
holes on Steel Board and fix it with the Washers, Spring Washers and Screw Nut above
mentioned.
4. Mount the heater onto the wall or ceiling by sliding Upper Bracket into the open on
Steel Board. Fix them together with screw M8*75 and M8.
5. Use a screw driver to unscrew the Screw M8*75 a little bit. Set the heater to a desired
angle and drive Screw M8*75 tight. The adjustable angle is within 60 degree totally.
Operations:
1. Plug in the unit to a socket. Make sure the power supply is same as rated.
2. Press Switch on left side of the heater to switch on/off the heater as desired.
Cleaning:
Unplug the unit before cleaning. It should be wiped with wet cloth.
Do not use too much water.
Disposal of appliances and batteries
After the implementation of the European Directive 2002/96/EU in the national
legal system, the following applies:
Electrical and electronic devices may not be disposed of with domestic waste.
Consumers are obliged by law to return electrical and electronic devices at the
end of their service lives to the public collecting points set up for this purpose
or point of sale. Details to this are defined by the national law of the respective country. This
symbol on the product, the instruction manual or the package indicates that a product is
subject to these regulations. By recycling, reusing the materials or other forms of utilising
old devices, you are making an important contribution to protecting our environment.
