2
Workplace
Your workplace should be assessed for the following hazards: heat, flames, chemicals, electrical,
environmental, sharp objects, unstable/uneven or slippery surfaces or moving equipment. Identify the
potential hazards and plan the installation of the lifelines to avert dangerous areas, zones and obstructions.
Always have an emergency rescue plan in the event that an accident occurs.
Components
This product is twisted rope with one eye termination and made of the following three parts:
Energy absorbing lanyard (1858007-ANSI)
+
Rope Grab (N-630)
+
Lifeline (1858043-xx)
WARNING:
n
These instructions must be provided to the end user of this product.
n
It is the responsibility of the user to read and understand these instructions before using this
equipment or to have them explained. Failure to do so could result in serious injury or death.
n
Certified fall protection and product training is highly recommended before using this equipment
and may be required by local Occupational Health and Safety Regulations.
n
Any alteration or misuse of this product is forbidden and may result in serious injury or death.
n
Only PALOMA, or entities authorized in writing by PALOMA, shall make repairs or alterations to the
equipment.
n
Only use components rated for the same weight capacity. Not all fall protection components are
rated for the same user weight capacity.
n
Only use combinations of fall arresters, lanyards, and lifelines approved by the manufacturer. Affect
or interfere with the safe function of each other may result in serious injury or death.
n
Proper precautions should always be taken to remove any obstructions, debris, material, or other
recognized hazards from the work area that could cause injuries or interfere with the effective
operation of the system.
n
Do not use this equipment around moving machinery and electrical hazards.
n
Protect all synthetic materials from slag, hot sparks, open flames and other wear and tear.
n
Do not expose equipment to environmental hazards and chemicals which may produce a harmful
effect.
n
Do not allow equipment to come in contact with anything that will damage it including: sharp
edges, abrasive surfaces, or high-temperature applications like welding, heat sources, and electrical
areas.
n
Evaluate space below work area to ensure potential fall path is clear of obstructions.
n
Allow adequate fall clearance below the work surface.
n
Do not expose the equipment to any hazard which it is not designed to withstand. Consult PALOMA
in cases of doubt.