
6
KODO 72 OUTDOOR FIREPLACE - Match-lit | Installation & Owner’s Manual
TO ASSEMBLE THE FIREPLACE
1. Ensure the fireplace surround is anchored per specifications.
2. Connect the Burner Assembly to the gas supply using the supplied
flex connector, following the instructions on page 8.
3. Carefully leak test all connections following the procedure on page 8.
4. Fill the burner trough evenly with burner media (crushed tempered
glass for natural gas; volcanic rock for propane). Do not obstruct the
pilot ignition port with burner media! Do not use media not supplied
by Paloform!
5. Place the burner assembly on a stable surface. Ensure burner is level.
6. Follow the Initial Lighting Instructions on page 10. Make sure that
the flame is even along the burner length and appliance is fully
operational and safe for use. Turn OFF the appliance and let it cool
before proceeding to the next step.
7. Carefully lift the burner and place it in the opening in the surround.
(See page 3)
8. Place and evenly distribute decorative topping media (lava rock
or tempered glass pebble) on top of burner media. (See page 7).
Decorative media should be brought level with the top of the pilot
cover. An uneven or excessively thick layer of topping can result in an
uneven flame.
Do not obstruct PILOT IGNITION PORT!
9. Correct flame appearance:
WARNING:
Failure to position parts in accordance
with these diagrams and instructions
and/or failure to use parts specifically
approved for use with this appliance may
result in property damage or personal
injury.
Do not remove the data plates attached
to the Outdoor Fireplace Burner. These
plates contain important information.
NOTICE:
Installation and repair should be done by
a qualified service person. The appliance
should be inspected before use and at
least once annually by a qualified service
person. More frequent cleaning may be
required as necessary. It is imperative
that control compartment, burner ports
and circulating air passageways of the
appliance be kept clean.
CAUTION:
New Lava Rock may pop or crackle when
first heated. This should subside after 30
minutes to one hour or more of operation.
Maintain safe distance during this time.
ASSEMBLY
DECORATIVE
TOPPING
BURNER
MEDIA
IGNITION
PORT