Page 1 of 2
ION 9200
Quick Start Guide
Before You Begin
Use this document to install and set up your Prisma SD-WAN ION 9200. Refer to the ION 9200
Hardware Reference at
https://docs.paloaltonetworks.com/hardware/ion-9200-hardware-
reference
for safety information, specifications, and more detailed procedures for installing the
device.
•
Verify that the installation site has adequate air circulation and AC power.
•
Have a #1 and #2 Philips-head torque driver available. Use the #1 Phillips-head bit to attach
the rack-mount brackets to the
device
and use the #2 bit to secure the rack-mount brackets
to the equipment rack posts.
•
Unpack the equipment and verify that you received the following items:
Items
Quantity
ION 9200
1
AC Power Cord
2
USB 2.0 to RJ45 Console cable
1
Shielded RJ-45 CAT6 Ethernet cable
1
Velcro
1
1RU mounting ears (left and right)
2
Rear support brackets
2
Adjustable mounting brackets (left and right)
2
#6-32 x 5/16” rack-mount screws
13
#10-32 x 3/4” rack-mount screws
9
#12-24 x 1/2” rack-mount screws
9
#10-32 nut cages
8
End User License Agreement (EULA)
1
China RoHS Declaration
1
docs.paloaltonetworks.com
Rack Mount the Device
Install the ION 9200 in a 19” four-post equipment rack using the four-post rack kit.
1
Attach one rack-mount bracket to each side of the ION 9200 (Figure 1) in the front-mount
position using four #6-32 x 5/16” screws for each bracket and torque to 9 in-lbs.
2
Attach one rack-mouunt rail to each side of the device (Figure 1) using two #6-32 x 5/16”
screws for each rail and torque to 9 in-lbs.
1
2
3
With help from another person, hold the device in the rack and secure the front rack-mount
brackets to the front rack-posts (Figure 2) using two screws for each bracket.
◼
Use the appropriate screws (#10-32 x 3/4” or #12-24 x 1/2”) for your rack and torque to 25
in-lbs.
◼
Use cage nuts to secure the screws if the rack has square holes.
4
Slide one back rack-mount bracket into each of the two previously installed side rack-mount
rails (Figure 2) and secure the brackets to the back rack-posts using the appropriate screws for
your rack (#10-32 x 3/4” or #12-24 x 1/2”) and torque to 25 in-lbs.
Figure 1 - Attach the accessories to the device
Figure 2 - Install the device in the rack
