MAINTENANCE / REP
AIR
TROUBLESHOOTING
OPERA
TION
ASSEMBL
Y / INST
ALLA
TION
SAFETY
/ SPECIFICA
TIONS
GETTING ST
ARTED
6
Extension length
Wire Size
A.W.G.
Up to 25 ft.
16
25 to 100 ft.
14
NOTE: Using extension cords over 100 ft. long is not
recommended.
ASSEMBLY/INSTALLATION SET UP
Lifting and setting up your machine
Make certain that slings, cables, chains,
forklifts or other load suspending gear or
machines used to move this unit are properly rated to handle
the weight. The Model 9682122 Surface Grinder is heavy.
The machine must be properly secured
and anchored to a base or stand before
use. Make sure that it is supported equally on all four
corners. Failure to comply may result in the machine
twisting and causing binds in the working table.
1. Remove any crating or overpacking materials which may be
covering the machine. Leave the machine attached to the
pallet.
2. Remove all accessory items from the pallet or machine table.
Compare these items with the listed on page 3.
3. The machine must be placed on a solid base or stand free
from any vibrations transmitted from adjacent machines.
4. Check all lock handles on the machine to ensure they
are tight. The table of the machine must be secure before
moving. Insert and tighten the lifting eyebolt.
5. Remove all the nuts and/or bolts securing the machine to the
pallet.
6. Center an hydraulic lift, forklift or other suitable overhead
lifting device and sling arrangement over the machine.
7. Carefully lift the machine off the pallet using the supplied
eyebolt. Lift the machine no higher than necessary to clear
the hold-down hardware and pull the pallet out of the way.
DO NOT place your hands or feet underneath the machine
when removing the pallet.
8. Place the machine into a final position onto the provided
base or stand.
Mounting and leveling
The surface grinder must be mounted and leveled for accurate
performance.
• Secure the machine onto the supplied cabinet base using
bolts provided with the tool.
• Place a highly accurate spirit level on the mounting chuck.
Shim the corners to level the machine to the left and right
and front and back. A level machine is crucial in providing
accurate machine operation.
Machine dimensions
38-3/4”
38-3/4”
41”
Front View
Side View
28-3/4”
NOTE:
The above diagrams show the reasonable approximate
dimensions of the machine and its parts. When
determining a final location for your machine ensure
there is enough clearance for both the operator and for
technicians who will service the machine. Also consider
any larger workpieces that would extend beyond the
machine’s table and require extra space.