Palmgren 9682096A, Operating Manual & Parts List

Page: 19 / 33

Page 7
GU1 GB
1.4 Reasonably foreseeable misuse
The installation of chip-type machines for tools with geometrically indeterminate cutting on the
machine substructure GU1 must only be done by qualified personnel.
Qualified personnel
Due to their professional training, knowledge and experience as well as knowledge of relevant
regulations, qualified personnel are able to perform the assigned tasks and to independently
recognise and avoid any possible dangers.
Any use other than that specified under "Intended use" or any use beyond that described will be
deemed non-intended use and is not permissible.
Any other use must be discussed with the manufacturer.
1.4.1 Avoiding misuse
Workplace limits
During activities that involve ablating machines, the general dust limit (inter alia) pursuant to
TRGS 900 should be observed with regard to the release of aluminium, aluminium hydroxide,
aluminium oxide (except aluminium oxide smoke), iron (II) oxide, iron (III) oxide, graphite, and
magnesium oxide (except magnesium oxide smoke). For fraction absorbable by alveoli, the
limit is 3 mg/m
3
and for the respirable fraction, 10 mg/m
3
.
Where toxic, highly toxic, carcinogenic, mutagenic or fertility-damaging substances may be
released, additionalsafety measures in accordance with §10, GefStoffV are necessary. In the
case of fertility-damaging substances, the German Maternal Safety and Parental Leave Ordi-
nance (MuSchEltZV) should be observed.