12
ENGLISH
DEUTSCH
2
CoNNECToRS
&
CoNTroLS
:
rear PaNeL FeaTureS
17 MaiNS iN
This is the socket for the included IEC power cord.
Caution: Do not operate the amp without the protective grounding connector!
Make sure the available mains input voltage matches the specifications on the rear panel of the amp before
powering up!
18 MaiNS FuSe
The mains fuse is held in the IEC socket. Replace with the same type and value fuse only (see technical specifica-
tions).
19 HeaTer FuSe
This holds the heater fuse for the preamp and power tubes. Replace with the same type and value fuse only (see
technical specifications). Tubes should be checked for defects if the heater fuse keeps blowing after replacement.
20 aNoDe FuSe
This holds the anode fuse for the power tubes. Replace with the same type and value fuse only (see technical
specifications). The power tubes should be checked for defects if the anode fuse keeps blowing after replacement.
21 2ND LeveL
This controls the alternate master level which is footswitchable with the dedicated 4-on-the-floor switch.
FooTSwiTCH
Connect the TRS leads from the Palmer 4-on-the-floor switch to remotely select channels, gain mode, master or
2nd level, and to turn the reverb on and off.
22 CHaNNeL/ GaiN SeLeCT
23 2ND LeveL/ reverb oN/oFF
FX-LooP (Tube DriveN)
This is where you connect external effects.
24 FX-SeND
This is the direct signal output. Connect this to the input of your effect(s).
FUSE
FUS
E
FUSE
FUS
E
FUSE
FUSE
FUSE
z
18
19
20
21 22 23
24
26
Summary of Contents for FAT50
