![background image](http://html1.mh-extra.com/html/pallmann/dust-m/dust-m_manual_748110018.webp)
-
3
몇
Warning
Do not vacuum without the filter elements;
otherwise, the suction motor can get dam-
aged and this can be hazardous to health
on account of increased release of fine dust
particles.
The horn blows when the air speed falls be-
low 20 m/s.
Note:
The horn reacts to negative pressure.
Î
Set the rotary switch to the correct suc-
tion hose cross-section.
Static charge is deflected by providing
earthing to the connection nozzles. This
prevents the formation of sparks and cur-
rent shocks due to attachments (option)
with electrical conductivity.
–
The device is fitted with a paper filter
bag with locking slide, order no. 60940
(5 pcs).
Note:
You can use this appliance to take up
all types of dust up to dust class M. It is stat-
utorily necessary to use a dust collection
bag (see Filter systems for order number).
Note:
The appliance is suited as industrial
vacuum cleaner and as dedusting device
for the mobile operation to take up dry, non-
combustible dusts with MAK values greater
than or equal to 0.1 mg/m
3
.
몇
Warning
The flat pleated filter must must always be
in place while vacuuming.
–
To vacuum fine dust, you must use an
additional paper filter bag or a mem-
brane filter (special accessory).
Illustration
Î
Release and remove the suction head.
Î
Insert the paper filter bag.
Î
Insert and lock the suction head.
Danger
The membrane filter must not be used to
vacuum health-hazardous dusts.
Note:
If you work without the paper filter
bag, you must use a membrane filter to pro-
tect the suction head.
Illustration
Î
Release and remove the suction head.
Î
Pull the membrane filter (option) over
the container edge.
Î
Insert and lock the suction head.
Danger
No dusts hazardous to health should be
sucked in during wet vacuuming.
Illustration
Î
Remove the brush strips.
Î
Install the rubber lips.
Note:
The structured side of the rubber lips
must point outwards.
Illustration
Î
Properly insert the connection socket in
the suction connection.
Î
Push in the connection socket until it
locks into place.
Î
Turn the suction connection with the
connection socket to the right to close it
tightly.
Note:
The accurate fit is ensured by means
of a "bayonet connection".
Illustration
Î
Release and remove the suction head.
Î
Pull the paper filter bag out towards the
rear.
Î
Pull the locking slide up and seal the paper
filter bag tightly when removing it.
Î
Dispose off the used paper filter bag in a
dust-tight bag according to the statutory
provisions.
Î
Insert and lock the suction head.
–
To suck wet dirt, first remove the paper
filter bag.
Horn
Anti-static system
Dry vacuum cleaning
Inserting the paper filter bag
Install membrane filter
Wet vacuum cleaning
Inserting the rubber lips
Close the suction connection
Remove the paper filter bag
18
EN
Summary of Contents for Dust M
