6
Athalon
®
CM & Crixus
™ User Manual
harmful interference in which case the user will be required to correct the
interference at his own expense.
This device uses RF energy to communicate. To reduce RF Exposure, this device
must be installed in a manner to ensure at least 20cm separation is maintained
between the device antenna and the body of the user or nearby people.
1.2.1.3.
ISED (Canada) Notice
The device complies with Industry Canada’s license-exempt RSSs. Operation is
subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Cet appareil est conforme aux normes d’exemption de licence RSS d’Industry
Canada. Son fonctionnement est soumis aux deux conditions suivantes: (1) cet
appareil ne doit pas causer d’interférence, et (2) cet appareil doit accepter toute
interférence, notamment les interférences qui peuvent affecter son fonctionnement.
1.2.1.4.
Power Connection
CAUTION:
To ensure the safe operation of the equipment the WiFi
Gateway must be powered from an NEC Class 2 power supply that is
certified as a Limited Power Source (LPS). Pall Corporation requires
that certified electricians complete all wiring connections from the Wi-
Fi Gateway to the external power supply, and from the external power
supply to the AC power mains.
The WiFi Gateway provides a barrel jack that is identified by the port label on the
Gateway for connection to an external DC power supply. The barrel jack has in
inside diameter of 2.5mm for the positive DC connection and a 5.5mm outside
diameter for the negative DC connection.
The DC supply must meet the following requirements for proper operation of the
Wi-Fi Gateway:
1.
DC Output Voltage Range:
4.5 – 6.5 VDC
2.
DC Output Current:
1.25 A Minimum
3.
Supply must be an NEC Class II power supply that is certified as a
Limited Power Source (LPS)
