Palfinger RC 400 P2, Operating Instructions Manual

Page: 16 / 18

Remote control operation
3-10
3-10 Stop working with the remote control
•
Move crane into transport position.
•
Switch remote control system off.
•
Keep the remote control transmitter in a safe place.
3-11 Battery of the remote control system
Charge battery:
Leave the battery in the transmitter of the RC system until an acoustic interval signal indicates that the
battery needs charging.
If you take out the incompletely discharged battery from the charger
this causes the memory effect. The battery looses charging capacity.
If you take out the battery of the transmitter before the acoustic inter-
val signal sounds the battery looses charging capacity.
Put battery into the battery compartment of the charger. LED (Charging) flashing green on the
charger.
Charging time approx. 3 hours.
LED (Ready) is green when charging is finished.
When the battery is completely loaded the charger switches to trickle charging. This prevents the bat-
tery from self-discharging.
3-12 Attaching and uncoupling of load by the crane operator
Accidental activation of a crane function may occur if the load is at-
tached or uncoupled by the operator. In such a case there is life-
threatening danger.
Operator attaches the load:
•
Move the lift arm to the specified place.
•
Activate the emergency stop button. No crane movement should be possible.
•
Attach the load on the load attachment correctly.
•
Leave the danger zone.
•
Release the emergency stop button.
Crane operation allowed again.
Operator uncouples the load:
•
Lift the load to the designated position.
•
Activate the emergency stop button. No crane movement should be possible.
•
Release the load from the load attachment properly.
•
Leave the danger zone.
•
Release the emergency stop button.
Crane operation allowed again.