
WARNING! Before leaving the operator's seat: Lower the lift arms against frame and
place both skid shoes on the ground. Disengage auxiliary hydraulics. Stop
Engine. Engage parking brake. Remove the key.
DANGER! ROTATING BLADE HAZARD! STAY BACK!
OBJECTS CAN BE THROWN!
DO NOT operate near bystanders.
DO NOT place hands or feet under deck while in operation or with engine
running.
DO NOT operate without a shatterproof door (or front shield) installed on
loader.
WARNING! Lift limiting chain must be properly installed before operation.
CAUTION! The front guard should always be in the down position except during
operation.
CUTTING OPERATION
1.
Raise the back of the unit off of the ground approximately 4" (102mm) to allow the
material to clear from under the cutting deck as you travel forward.
2.
Place the front skid shoes 2-6” (51-152mm) off the ground. This is the preferred position
for cutting grass and heavy vegetation.
•
Never drive your skid steer with the front of the brush cutter tilted to the point
your view is obstructed. Always make sure you can see what you are cutting.
•
Check the work area. Never operate the brush cutter in populated areas where
thrown objects could injure persons or damage property.
•
Never raise the unit and expose yourself or anyone else to the rotating blades.
If you can see the blades then the back of the unit is raised too high. Maximum
ground clearance at any time is 12” (305mm).
3.
Activate the auxiliary hydraulics with the engine at idle. Increase engine speed.
4.
Be sure the brush cutter is operating smoothly and at full speed, and then start forward
travel while monitoring pressure gauge (if so equipped).
NOTE: The GS Series (30-45 GPM) brush cutters have a pressure gauge located
on the back of the motor cover. Monitor hydraulic pressure to prevent forcing your
prime mover or attachment from repeatedly going over relief and therefore causing
overheating of the hydraulic system.
CUTTING LARGE BRUSH AND SMALL TREES UP TO 7" (178mm) IN DIAMETER:
WARNING! Trees can fall in any direction. It is the operator’s responsibility to be
certain the area is safe and clear of people, animals and personal property.
OPERATING INSTRUCTIONS
12145 12-20-17-2
16
75728
Summary of Contents for Bradco Extreme Duty Ground Shark Series
Page 4: ...2 75728...
Page 6: ...THIS PAGE IS INTENTIONALLY BLANK 4 75728...