150-231-185-05, Revision 05
Provisioning
HLU-231 List 8E
September 13, 1999
19
Set Clock Screen
Press
at the Maintenance Terminal Main Menu to open the Set Clock screen (
Figure 7.
Set Clock Screen
Set Time
The cursor defaults to the New Time field. To set the system time, type the hour and minute in the 24-hour format
of hh:mm:ss (setting the seconds is optional), then press
. The New Date field appears.
OFF
Off
No active loopback mode.
(PL)
Pay Load
The loopback was initiated by a command that was embedded in the
T1 data path.
SMJK
SmartJack Loopback
Loopback from HRU to network initiated by (2-in-5) inband loopback
code or out-of-band ESF data link code.
TLOS
Transmit Loss of Signal Loopback
HRU is in a logic loopback state caused by a loss of its T1 input from
the CI (if enabled at the HRU through its TLOS switch option).
All time information is lost when power is removed. The last date, however, is retained in
NVRAM and reappears when power is restored.
Table 7.
Loopback Messages (Cont.)
Message
Full Name
Description
%
SET CLOCK
TIME: 00:14:33
DATE: 09/15/99
CIRCUIT ID#:
Format: HH:MM
MM/DD/YY
NEW TIME:
NEW DATE:
(U)PDATE REMOTE?
(17(5
