Section 150-611-100
Revision 02
Page 25
TABLE 10. HLU-611 STATUS MENU DEFINITIONS
Message
Full Name
Description
ALARMS
NONE
No Alarms
LLOS
Local Loss of Signal
No signal from local T1 interface.
RLOS
Remote Loss of
Signal
No signal from remote T1 interface.
LOSW
Loss of Sync Word
The VHDSL’s loop has lost sync.
HES
VHDSL Errored
Second
The VHDSL’s CRC errors have exceeded the user-selected ES
threshold.
DS1
Digital Service 1
DS1 input BPVs have exceeded the user-selected ES threshold.
LAIS
Local Alarm
Indicating Signal
Indicates an AIS (all 1’s) pattern is being transmitted from the
local T1 output port.
RAIS
Remote Alarm
Indicating Signal
Indicates an AIS (all 1’s) pattern is being transmitted from the
remote T1 output port.
MAL
Margin Alarm VHDSL
The margin on the VHDSL Loop has dropped below the user
Margin Alarm Threshold (1 to 15). Setting the threshold to 0
(zero) inhibits the alarm.
LOOPBACKS
SMJK
Smartjack Loopback
Loopback at HRU towards network initiated by 2 in 5 in-band
loopback code or out-of-band ESF data link code. See Figure 5.
NREM
Network Remote
Loopback
Loopback at HRU (remote) towards network initiated by
addressable line repeater code, HRU front panel push-button,
HLU front panel manual loopback push-button, or maintenance
terminal. See Figure 5.
NLOC
Network Local
Loopback
Loopback at HLU (local) towards network initiated by addressable
office repeater code, HLU front panel manual loopback push-
button, or maintenance terminal. See Figure 5.
CLOC
Customer Local
Loopback
Loopback at HRU (local) towards CI initiated by addressable line
repeater code, HLU front panel manual loopback push-button, or
maintenance terminal. See Figure 5.
CREM
Customer Remote
Loopback
Loopback at HLU (remote) towards customer initiated by
addressable office repeater code, HLU front panel manual
loopback push-button, or maintenance terminal. See Figure 5.
ARM
Armed
HiGain has detected the addressable repeater loopback (2 in 5)
arming code.
TLOS
Transmit Loss of
Signal Loopback
HRU is in a logic loopback state caused by a loss of its T1 input
from the NI, if enabled via SAIS option.
