6
Once all of the wires have been connected to the switches, the polyethylene liner
can be installed. Decide which hole of the roll bar mounting box the wires will be exiting
and make a small hole in the liner. Then, pass the wires through the opening. Next, slide
the liner over the switches and flush up to the panel.
Install the rubber grommet in the corresponding hole of the roll-bar mounting box
and route the wires out that hole. Use the plastic plugs to fill the remaining holes. Secure
the switch panel with the liner installed down onto the box with the six screws provided in
this kit.
For dash mounted panels, you must cut a
9 ¾” x 2 ¼”
opening for the six switch
panel to allow room for the polyethylene liner.
The plastic wire ties are for looming and securing the wires to the vehicle.
The label sheet included is to identify each switch of its function. Simply peel off the
label needed and place it under the switch wired for that function. The "R" and "L"
labels are for right and left in the event an on/off/on switch is turned sideways for turn
signals
Painless Performance Products LLC
Limited Warranty and Return Policy
Chassis harnesses, fuel injection harnesses, and switch panel units are
covered under a lifetime warranty.
All other products manufactured and/or sold by Painless Performance are
warranted to the original purchaser to be free from defects in material and
workmanship under normal use. Painless Performance will repair or replace
defective products without charge during the first 12 months from the purchase
date. No products will be considered for warranty without a copy of the purchase
receipt showing the sellers name, address and date of purchase. You must return
the product to the dealer you purchased it from to initiate warranty procedures.