Pai Technology 62101, Instruction Manual

Page: 17 / 20

Before assembly, please prepare six 1.5 V AA batteries
and a Phillips head screwdriver (not included).
Button
Main control block battery
installation diagram
Note:
The following steps should be done
either by an adult or under adult supervision.
Installing the main control block ba�ery
- Use a Phillips head screwdriver. Unscrew the bo�om screws
counter-clockwise and remove the ba�ery cover.
- Insert four 1.5 V AA ba�eries in the direc�on indicated inside
the ba�ery compartment.
- Replace the ba�ery cover. Use the screwdriver and screw
clockwise to fasten.
- Press the bu�ons on the sides. The main control block indicator
lights will flash, and it will enter sync mode.
Remote control sync
- First, remove the transparent insula�on strap on the back.
Confirm the red indicator light in the front has started to flash.
- Confirm the main control block is on, then press any bu�on on
the remote control. The remote control will sync with the main
control block.
- A�er sync is complete, the light on the remote control will
automa�cally go out. If the indicator light con�nues to flash a�er
30 seconds, it means sync was not successful. Please re-start the
sync process again. (See the “Re-start sync” page.)
*If the remote control isn ’ t used in 20 minutes, the main control
block and remote control will go into standby mode. To use
again, please first press the bu�on on the side of the main
control block.
Preparation