11
300-800 mm
Liner
Plywood
Kabeldistans
Väggmatta
LED light type 300 Marine
ENGLISH
MA50-09 GB 2018
Type 300CA - for pool with liner
Item no 124291: LED red/green/blue
Item no 124391: LED white
Mounting instructions:
1. Make a hole in the framework, see a cross-section for making holes.
2. Apply some water-resistant grease in the threads of the niche.
3. Attach and secure the niche to the pool frame with the cable outlet pointing upwards.
4. Thread the cable conduit in the niche and in the junction box. The thread shall be sealed with e.g. thread tape.
The cable conduit shall be placed so that the bend radius is not below 100 mm.
5. Fixate the self-adhesive packing on the brim of the niche.
6. Insert the liner.
7. Fill the pool with water up to about 10 cm below the niche, make a small cut in the liner in the center of the niche
(not to close to the edge).
8. Mount the sealing ring with the packing under.
9. Cut the liner clean around the inside of the sealing ring.
10. Place the supplied spacer on the cable of the lamp where it runs through the cable gland of the niche.
Tighten the cable gland in the niche to seal the cable. Insert the cable in the conduit and connect to the junction box.
Wrap excess cable behind the lamp and assemble the lighting unit in the niche.
11. Mount the front ring.
- for pool walls of
wood, sheet or plastic
Fix and secure the niche into
the pool framework with the
supplied screws and washers.
Liner
Plywood
Spacer
Wall mat
Washer (3x)
Conduit
Sealing ring
Front Marine
Washer (6x)
Countersunk screw
M5x10 (6x)
Gasket 3mm
Screw (2x) M5x20
Lamp unit
Liner
Niche
Wall mat
Nut M6 (3x)
Pool frame work
plywood/sheet
Gasket 1.5 mm self-adhesive
Countersunk
screw M6x20 (8x)
