CHARGING THE PAGER
1. Do not stack more than 10 guest pagers on a single charging base.
2. Do not connect more than 1 charger base to a single power supply.
3. Only use the power supply that came with your system.
4. Charge pagers for 24 hours prior to first use.
Note: Keep rechargeable pagers on charge even during extremely long periods of inactivity.
WARNING: Damage caused from improper electrical connection including but not limited to the
incorrect power supply is not covered under the standard warranty. If you’re uncertain about which
power supply to use, contact our customer support department.
●
The pager will display LOBT when battery level is low. This means it will turn off
within the next 20min approximately.
●
Place the pager on the charging base and wait until the GREEN appears on the pager,
this means the pager is fully charged.
OPERATING THE SYSTEM
1. When a guest arrives, remove a pager from the charging stack. Pagers will light up for the
amount of seconds that it's programmed to alert.
2. Record the pager number and hand it to your guest.
3. Page the pager by entering the number into the transmitter.
4. Pagertec Simple Alert Pagers will flash or vibrate (if enabled) depending on the
page mode.
Note: Beep modes will still flash and vibrate (if enabled) with no audible beep.
