6
BATTERY INSTALLATION
The rechargeable nickel metal hydride (NiMH) batteries will typically last from one to
three years depending on usage. To replace the battery pack, first remove the battery door
screw from the rear of the pager using a small Phillips head screwdriver. Lift the battery
door from the bottom to open. Place the door and set screw in a safe place for closure
after changing the rechargeable batteries. To facilitate battery replacement, in situations
where the low-profile belt-clip is in use, temporarily remove the belt clip too. Next, carefully
remove the old batteries. Place in the new replacement batteries (2 AAA NiMH batteries).
Replace the battery door and re-secure it into place using the Phillips head set screw.
CLIP REPLACEMENT
To replace a damaged clip from a pager, first you must remove the clip to do this use
lever located on the top of the pager between the plastic pager housing and the metal clip.
Use a small flat head screw driver and insert it between the plastic lever and the pager.
This will release the metal clip from the pager. Then, slide the metal clip out from the pager.
Replace clip with an appropriate replacement part available for purchase as an accessory
from Pagertec.
