![Paderno 043-5266-6 User Manual Download Page 10](http://html1.mh-extra.com/html/paderno/043-5266-6/043-5266-6_user-manual_746819010.webp)
Product No. 043-5266-6
10
7.
Press “Start/Pause” to temporarily
stop brewing cycle. Press “Start/
Pause” again to resume process.
8.
When brewing cycle is complete,
the coffee maker will beep. The
coffee maker will go into “Keep
Warm” function, and the “Keep
Warm” button will become
illuminated. The display screen will
show time count up to indicate time
elapsed in “Keep Warm” function.
After 30 minutes, the machine will
beep and the “Keep Warm” button
will turn off.
NOTE: Keep Warm can only be used
when Brew Size setting is set to “Full
Batch”.
NOTE: To deactivate “Keep Warm”
function, press the button again. If
the button is pressed after the 30
minutes are done, “Keep Warm”
function will activate again.
9.
Remove the glass carafe to serve
when finish brewing (remove about
one minute later after the coffee
stops dripping).
NOTE: The coffee you get will be
less than the water you have added,
as some water is absorbed by the
coffee grinds.
10.
Always turn the coffee maker off and
disconnect power supply when not
in use.
NOTE: Pay attention when pouring
the coffee, to avoid spilling coffee.
Coffee will be hot and may
cause injury.
Operating Instructions
1.
Open the top lid and fill the water
tank with cold drinking water. The
water level should not exceed
MAX level as indicated on the water
level gauge.
2.
Place the funnel into the funnel
support and ensure the funnel is
positioned correctly. Then place
the permanent filter or filter paper
in the funnel, and ensure it is
positioned correctly.
3.
Add proper coffee grinds into
permanent filter or filter paper.
Usually a cup of coffee needs a
level spoon of coffee grinds, but
you may adjust according to your
personal taste.
4.
Insert the glass carafe on the
warming plate horizontally.
5.
To reset brewing preferences, click
dial to enter “Brew Settings” mode.
6.
To begin brewing immediately,
press “Start/Pause” button. The
“Start/Pause” and “Cancel” buttons
will become illuminated. The display
screen will show time count up
during brewing process.
NOTE: Glass carafe can be removed
at any time during brewing cycle.
The appliance will stop dripping
automatically. The carafe should
be put back into position on the
warming plate within 30 seconds.