INSTALLATION GUIDE
FPNN Series LED Flat Panel
Instructions and specifi cations are subject to change at any time without notice. Copyright© 2022 PacLights All Rights Reserved
Page 2 of 3
Need help? (800) 988 -6386 Email: [email protected] Website: www.PacLights.com
PL_INST_FPNN_v0
The Mounting Clips (4) are located at the sides of the FPNN fi xture
(Fig. 4). Use Pliers to bend the Mounting Clips at the appropriate
bending points. First bend up at the base, then carefully bend out to
90°at the top of the Clip (Fig. 5) (For safety wear work gloves).
1
FPNN MOUNTING ONTO T-GRID
MOUNTING
CLIPS
BEND
POINTS
Insert the FPNN fi xture onto the T-Grid (Fig. 6). The Mounting Clips
will set on top of the T-Grid.
2
OPTIONAL FPNN SURFACE MOUNT
FIG. 4
FIG. 6
Secure Safety Cable to Mounting Clip holes as needed to meet local
seismic requirements. Safety Cable and method of attachment to the
building provided by contractor according to local building codes. Use a
Safety Cable (hanger wire) to tie off appropriately (Screws and hanger wires
supplied by others) (Fig. 7).
SAFETY
CABLE
TIE OFF
FIG. 7
FIG. 5
FPNN
FIXTURE
1
FIG. 8
SCREWS
CHANNELS
Fasten the three Channels of the Surface Mount to the Ceiling
surface. Mounting Bolts/Screws not provided (Fig. 9).
2
Slide in the FPNN fi xture through the open side of the Surface Mount
(Fig. 10). This is when all the wiring installations should be made as
well. Refer to the wiring diagram.
3
Start off by assembling three of the Channels together. Use Screws to
fasten the Angles to the corners of the Channel frame (Fig. 8).
FIG. 9
FIG. 10
Once the FPNN fi xture is properly installed into the Surface Mount,
fasten the last two Angles and side Channel with Screws to completely
enclose the FPNN fi xture (Fig. 11).
4
ANGLE
SURFACE
MOUNT
SURFACE
MOUNT
FPNN FIXTURE
FPNN FIXTURE
ANGLE
CHANNEL
FIG. 11
T-GRID
SCREWS
HASP
FPNN
FIXTURE
CEILING
SCREWS
OPTIONAL FPNN SUSPENDED MOUNT
