background image

INSTALLATION GUIDE

FFHS/3 Series LED Sports Light

Instructions and specifi cations are subject to change at any time without notice.  Copyright© 2022 PacLights   All Rights Reserved 

Page 2 of 2

Need help?  (800) 988 -6386   Email:  [email protected]  Website:  www.PacLights.com 

PL-INST-FFHS/3-v0

The Slipfi tter can be mounted easily to the FFHS/3 fi xture (Fig. 3).  
Carefully slide the Fixture Cable through the Slipfi tter and fasten the 
Slipfi tter to the FFHS/3 fi xture.    

 

1

OPTIONAL ADJUSTABLE SLIPFITTER MOUNT

FIG. 3

2

FIG. 5

3

FIXTURE CABLE

FIG. 4

WASHERS

BOLTS

SLIPFITTER

The FFHS/3 fi xture can be rotated by adjusting the Slipfi tter angle.  
Loosen the Bolt or remove if necessary (Fig. 5).  Set the adjustable 
Angle (0°-90°, up or down) on the side of the Slipfi tter, then fasten 
the Bolt to secure the Slipfi tter in place (Fig. 6).     

POLE

BOLTS

POWER CABLE

LOCK WASHERS

FFHS/3 FIXTURE

The Slipfi tter (inside diameter 2 3/8”) can be mounted to fi t 2” 
Nominal Round Poles.  Loosen the Slipfi tter Bolts or remove if 
needed.  Attach the Power Cable to the Fixture Cable and install the 
FFHS/3 fi xture with the Slipfi tter onto the Pole (Fig. 4).  Tighten the 
bolts to secure the Slipfi tter to the Pole.   

 

FIXTURE CABLE

FFHS/3 FIXTURE

FFHS/3 FIXTURE

SLIPFITTER

SLIPFITTER

BOLT

ANGLES

FIG. 6

CROSSBAR MOUNT 

The drilling template for the FFHS/3 Crossbar Mount is shown below for 
each Model (Fig. 11).   

 

   

 

FIG. 11

FFHS/3-600/750 

FFHS/3-400/500 

FFHS/3-1000/1200 

 ADJUSTABLE PROJECTION ANGLE 

The FFHS/3 fi xture has an adjustable Projection Angle located at the sides 
of the fi xture.  Loosen the Screws with a Hex wrench (Fig. 7).  Rotate the 
Housing down (Fig. 8).  Rotate the Housing up (Fig. 9).     

 

FIG. 7

FIG. 8

FIG. 9

SCREW

PROJECTION ANGLE

SCREWS

FIG. 10

The Optional Glare Shield provides a restriction for excess glare of light 
pollution and light trespass by the FFHS/3 fi xture.  Align the Glare Shield 
to the front of the FFHS/3 fi xture holes along the rim.  Fasten the Glare 
Shield to the fi xture with the Screws (Fig. 10).   

OPTIONAL GLARE SHIELD 

GLARE SHIELD 

Reviews: