INSTALLATION GUIDE
FFHS/3 Series LED Sports Light
Instructions and specifi cations are subject to change at any time without notice. Copyright© 2022 PacLights All Rights Reserved
Page 1 of 2
Need help? (800) 988 -6386 Email: [email protected] Website: www.PacLights.com
PL-INST-FFHS/3-v0
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
PacLights fi xtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is required for safety.
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR
WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNINGS:
•
Make certain power is OFF before installing or maintaining fi xture. No user serviceable parts inside.
•
To prevent wiring damage or abrasion, do not expose wiring to edges of sharp objects.
CAUTION:
•
For proper weatherproof function all gaskets must be seated properly and all screws inserted and tightened fi rmly. Apply weatherproof silicone
sealant around the edge of the Back Box and/or Junction Box. This is especially important with an uneven wall surface. Silicone all plugs and
unused conduit entries.
FFHS/3-400/500
FFHS/3-600/750
FFHS/3-1000/1200
Connect the ACL and the ACN from the FFHS/3 Fixture to the conduit with the AC power Supply Cable. Follow the Wiring Diagram provided.
AC POWER SUPPLY
FFHS/3 DRIVER
GRAY (-)
PINK (+)
HOT [BLACK]
NEUTRAL [WHITE]
GROUND [GREEN]
WIRING DIAGRAM
DIMMING
INPUT
FFHS/3 INITIAL SET-UP
FIG. 1
Install the Shorting Cap on the NEMA 7-pin twist-lock Control Receptacle
by carefully aligning and pressing down the plug into the socket and twisting
CW (Fig. 1). Note: If the Photocontrol is provided see the following for
instructions.
SHORTING CAP
FFHS/3 FIXTURE
RECEPTACLE
OPTIONAL PHOTOCONTROL
FIG. 2
The Photocontrol can be installed easily on all FFHS/3 Receptacles by
carefully aligning and pressing down the plug into the socket and twisting
CW (Fig. 2). Note: If the Photocontrol is not included this step can be
skipped. If the Photocontrol is included prior to fi eld installation the Initial
Set-Up can be skipped.
PHOTOCONTROL
RECEPTACLE
FFHS/3 FIXTURE
