INSTALLATION GUIDE
FALC/2 Series LED Area Light
Instructions and specifi cations are subject to change at any time without notice. Copyright© 2022 PacLights All Rights Reserved
Page 3 of 4
Need help? (800) 988 -6386 Email: [email protected] Website: www.PacLights.com
PL-INST-FALC/2-v0
FIG. 12
4
Install the FALC/2 to the Arm Mount. Attach the fi xture Cable to the
Power Cable (Fig. 12). Replace the Cover. Refer to Fig 10.
FIG. 10
GASKET
FALC/2 FIXTURE
FIG. 11
OPTIONAL ARM MOUNT
The FALC/2 Arm Mount can be used on either a Round or Square
Pole. The drilling template for both the Round and Square Poles is
shown below (Fig. 8). Drill holes on the Pole by following the drilling
template to mount the FALC/2 to the desired height (Fig. 9).
1
FIG. 8
SCREWS
Remove the Screws and the Cover from the Arm Mount prior to
installation (Fig. 10).
2
FIG. 9
COVER
ARM MOUNT
Ø 0.375” Clearance
holes on pole to align
with Locking Plate
hole locations
Ø 0.56”x 1.17” Slot to
run Power Supply Cable
through the Pole into
the Arm Mount
Install the Arm Mount to the Pole with the Gasket. Place the Locking
Plate inside the Pole and carefully place the Power Cable through the
Arm Mount. Fasten the Bolts and hardware (Fig. 11).
3
ARM MOUNT
WASHERS
LOCK WASHERS
BOLT
CABLE
POWER CABLE
LOCKING PLATE
WASHERS
LOCK WASHERS
BOLT
POWER CABLE
OPTIONAL ADJUSTABLE ARM MOUNT
The FALC/2 Adjustable Arm Mount can be used on either a Round
or Square Pole. The drilling template for both the Round and Square
Poles shown below (Fig. 13). Drill holes on the Pole by following the
drilling template to mount the FALC/2 to the desired height (Fig. 14).
1
FIG. 13
Install the Adjustable Arm Mount to the Pole with the Gasket. Place
the Locking Plate inside the Pole and carefully place the Power Cable
through the Adjustable Arm Mount. Fasten the Bolts and hardware
(Fig. 15).
2
FIG. 14
Ø 0.375” Clearance
holes on pole to align
with Locking Plate
hole locations
Ø 0.56”x 1.17” Slot to
run Power Supply Cable
through the Pole into the
Adjustable Arm Mount
FIG. 15
SCREW
COVER
ADJUSTABLE
ARM MOUNT
WASHER
LOCK WASHER
BOLT
GASKET
LOCKING PLATE
POLE
Install the FALC/2 fi xture to the Adjustable Arm Mount. Open the
Cover by removing the Screw. Carefully place the fi xture Cable
through the Adjustable Arm Mount and attach to the Power Cable
(Fig. 16). Close the Cover and fasten the Screw when done.
3
FIG. 16
FALC/2 FIXTURE
POWER CABLE
CABLE
BOLT
WASHER
LOCK WASHER
POLE
4
The FALC/2 fi xture can be rotated upward by adjusting the Adjustable
Arm Mount angle. Loosen the Bolt or remove if necessary. Set the
Angle on the side of the Adjustable Arm Mount, then fasten the Bolt
to secure the Adjustable Arm Mount in place (Fig. 17).
FALC/2 FIXTURE
ADJUSTABLE
ARM MOUNT
BOLT
FIG. 17
ANGLES
