Packet Power Multi-Circuit Monitor BGS32 User Manual V2.0
© 2021 Packet Power, LLC
Page 10 of 29
SECTION 3: INSTALLATION
IMPORTANT
1.
Installation should be conducted by a qualified professional according to local
electrical codes.
2.
Protective equipment should be used when handling a current transducer (CT) on a
live conductor.
3.
Do not make adjustments to the BGS32’s internal wiring.
4.
If you believe the BGS32, CTs, interconnect boards or leads have been damaged, do
not attempt to repair or use them. All components are built to spec by Packet Power
and are not intended for alteration in the field.
Please review the complete list of safety instructions in the Hazards sections of this
document.
Installation Overview
The BGS32 does not need to be configured prior to use.
1.
Mount the BGS32 to wall or device using mounting tabs provided.
2.
Run the voltage lead(s) to the voltage source and connect them to L1, L2, L3, N and
earth.
3.
Mount the CT Interconnect Boards near the circuits being monitored.
4.
Attach the connector at the end of the CT Interconnect Cable to the applicable CT
Interconnect Board header.
5.
Run CT leads from the CT Interconnect Board to the respective circuits.
6.
Connect each CT to the appropriate conductor.
7.
Connect CT tails to the CT leads.
Once power is supplied, the BGS32 will automatically begin to transmit data.
Thoroughly review the details for each step prior to installation. Contact Packet Power
support with questions.
