Packard Bell Grafite & Carbon Disassembly Manual
2
About this Guide
This guide contains systematic disassembly instructions for the Packard Bell Grafite & Carbon. The
instructions are illustrated where necessary with images of the part that is being disassembled.
Packard Bell B.V. reserves the right to make changes to the Grafite & Carbon without notice.
For More Information
For more information about the Packard Bell Grafite & Carbon, visit Packard Bell‘s support web site
at
www.packardbell.com
. The support web site also has links to additional Packard Bell
documentation and detailed specifications.
Technician Notes
Only technicians authorized by Packard Bell B.V. should attempt to repair this device. Because of the
complexity of the individual boards and subassemblies, no one should attempt to make repairs at the
component level or to make modifications to any printed wiring board. Improper repairs can create a
safety hazard. Any indication of component replacement or printed wiring board modifications may
void any warranty or exchange allowances.
Disassembly
When disassembling the device, follow these general rules:
Turn OFF the power using the power button and disconnect the AC adapter.
Do not disassemble the device into parts that are smaller than those specified here.
Label all removed connectors; note where the connector goes and in what position.
Use something to hold the small screws (trays, jars, or cups). Label each cup with the
disassembly step number. This can reduce questions about where each screw came from
during re-assembly.
Reassembly
Reassembly is the reverse of the disassembly process. Use care to ensure that all cables and screws
are returned to their proper positions. Check that no tools or any loose parts have been left inside the
device. Check that everything is properly installed and tightened.
The LED cable goes on the outside of the hard disk drive casing, not underneath the drive!
The spacer clips are fitted so that they touch the top cover when the device is on. They
have been designed to reduce vibrations during operation.
Required Tools
All disassembly procedures can be performed using the following tools:
Small Phillips screwdriver.
