background image

9

How to replace

Disconnect cleaner from electrical
outlet.

To change filter bag, unzip outer bag,
grasp sides of filter bag collar (A) and
pull collar from tube.

Note:  Do not 

clean out old filter bag

and reuse.  Discard used filter bag.

Clearing blockages

To check for obstructions, first 

turn

cleaner off and disconnect from
electrical outlet; then disconnect
hose from cleaner. 

Open hose

door (E) and carefully remove any
visible obstruction. If no obstruction
is found, check hose and tools.
Remove obstruction. To continue
using tools, re-attach hose to clean-
er. If no obstruction is found and a
problem persists, contact your
Pacific Floor Warranty Service 
Dealer.

How to clean tools

To clean the hose, wipe off dirt with
a cloth dampened in a liquid deter-
gent. Rinse with a damp cloth.
Cleaning tools may be washed in
warm water with a detergent. Rinse
and air dry before using.

Attach wand and tools

The tools are attached to the hose or
the wand in the same manner. Push
tool firmly onto hose; twist tool slight-
ly to tighten or loosen connection.

Use cleaning tools with cleaner han-
dle in upright position.

42

43

Maintenance

Disconnect cleaner from electrical
outlet before attempting to service
it in any manner.
Do not operate without paper bag
in place.

The filter bag

When to replace

Check filter bag from time to time. It
is recommended that you change
the filter bag when dirt reaches the
dotted line. If more dirt than this
accumulates, your cleaner may not
operate effectively.

Note: 

Check and change the filter

bag frequently when using cleaner
on new carpet due to rapid accumu-
lation of carpet fluff.

CAUTION:  Very fine materials,
such as face powder, cornstarch,
fireplace ashes or fireplace soot,
may seal the filter bag and may
cause it to burst even though it is
only partially full of dirt.  When
cleaner is used to remove material
of this nature, change filter bag
often.

Where to buy

Filter bags may be purchased from
Pacific Floor, Ph (800) 968-1332, or
online at

www.nextwaveofclean.com.

What to buy

To assure cleaning effectiveness,
use only 

Pacific Floor Type A dis-

posable

filter bags.

Continued 

Select proper tool

A. Dusting brush

may be used for

carved furniture, table tops, books,
lamps, lighting fixtures, venetian
blinds, baseboards, shutters, and
registers.

B. Furniture nozzle

may be used

for upholstered furniture, draperies,
mattresses, clothing, automobile
interiors, and carpeted stairs.

C. Crevice tool 

may be used in tight

spaces, corners and along edges in
such places as dresser drawers,
upholstered furniture, stairs, and
baseboards.

D. Wand 

is used to give extra length

to your hose.  Use it with any of the
above tools.

41

B

C

D

A

A

E

44

Summary of Contents for Upright Vacuum Cleaner














Reviews: