Pacific Floorcare S-24, Manual

Page: 15 / 92

RETURN TO
TABLE OF
CONTENTS
- 10 -
CHARGING
WARNING : Batteries emit hydrogen and oxygen gas.
• Keep sparks and open flame away.
• Do not smoke near the machine.
• Charge batteries in a well-ventilated area with the battery compartment open.
WARNING : Do not wear jewelry when working near moving or electrical components.
WARNING
: Do not plug in the charger cable if wall cord or battery harness is damaged.
NOTE : Do not use an extension cord with the battery charger. This will void the charger warranty.
NOTE : Ensure battery charging and storage locations comply with OSHA and any governing agencies’
standards based on your particular location and application.
The charger status LED’s (used to indicate the charger’s status while plugged in) can be viewed through the
view window located on the vertical kick panel below the seat.
LED INDICATION MEANING
GREEN flashing (2 seconds) Charger is set for AGM batteries
YELLOW flashing (continuous) Unsuitable battery connected or output short circuit
RED flashing (2 seconds) Charger is set for Lead Acid batteries
RED flashing (continuous) Safety timer exceeded or internal short circuit
Solid GREEN The unit is fully charged
Solid YELLOW Phase 2 of charging is in progress
Solid RED Charging cycle has begun
NOTE : Seat assembly must remain open while charging to prevent damage to the charger power cord.
CHARGER SETTINGS
SW1
DP2 DP1 APPLICATION
OFF ON LEAD-ACID BATTERIES
OFF OFF AGM FULLRIVER
ON OFF AGM DISCOVERY
ON ON GEL
SW2
DP2 DP1 CHARING CURRENT
ON ON 15A
ON OFF 20A
OFF ON 25A - XCF
OFF OFF 25A
SW1: Sets the current profile of the charger to the particular battery that is installed.
SW2: Set the current level of the charger based on the amp-hour
rating for the particular batteries installed.
CHARGING CURRENT BATTERY AMP HOUR RANGE (5h) BATTERY AMP HOUR RANGE (20h)
15A 100-150 Ah 130-180 Ah
20A 120-195 Ah 150-240 Ah
25A 180-258 Ah 220-315 Ah
ON-BOARD CHARGING