Pacific Floorcare RS28, Parts & Operating Manual

Page: 6 / 58

RETURN TO
TABLE OF
CONTENTS
- 3 -
UNPACKING THE MACHINE
TRANSPORTING THE MACHINE
Six (6) tie-down points (two on the front, two at the
front corners, and two at the rear corners) have been
provided on the frame to allow the machine to be
secured during transportation.
Ensure the machine is properly secured with suitable
tie-down straps before transporting the machine.
1. Remove outer cardboard packaging.
2. Remove the shrink wrap securing the ramp and allow the ramp (not shown) to lower to the ground.
3. Using a #2 Philips driver, remove the screws from the front and rear wood wheel chocks.
4. Using a 3/8” socket and driver or wrench, remove the screws from the tie-down straps located at each corner of the machine.
5. Turn the machine on using the key switch and carefully drive down the ramp.
6. Install the rear squeegee assembly (refer to the RECOVERY SYSTEM of this manual).
NOTE : Fully drain the Solution and Recovery tanks before loading.
NOTE : Ensure the ramp and truck/trailer are properly rated for the weight of the machine.
NOTE : Use a ramp with no more than a 12% incline to load and unload the machine.
NOTE : Transport the machine with the scrub head in the raised position.
NOTE : Do not lower the Orbital Scrub Head without a pad installed. Doing so will damage the Mighty-Lok
®
face.
NOTE : Remove the rear squeegee assembly before transporting the machine.
NOTE : Chock the wheels and tie down the machine.
NOTE: Actuate the Manual Brake Release lever before attempting to manually push/move the machine.