NEO 1.6 EU-En 200116-20
15
©PACIFIC ENERGY FIREPLACE
PRODUCTS LTD.
FIG. #8
Chimney
Roof flashing
Storm collar
* 100mm diameter air inlet with rodent screen
* If the crawl space is well ventilated it is not
necessary to extend air inlet to outside
Spark arrestor
rain cap
Radiation shield
Chimney Connector
Chimney Support
1500 mm)
Minimum
Minimum 2.415m.
Ceiling Height
Non-combustible
floor protector
1000 mm
*
Hooded vent or
90 elbow turned down
The chimney may incorporate
an offset. To do this safely, all
sections of listed connector,
offset elbows and chimney
section must be screwed
together by at least three
sheet metal screws per joint.
The chimney must be suitably
supported by the chimney
manufacturer's listed offset
support.
Alternate out and up
installation
12"(305mm)
Minimum first
section of pipe.
Wall Thimble
Unit may be harder to start.
Please provide as much verti-
cal length for the first section
of pipe as possible.
*
*
*
Check local and national codes
